Equinox Transfer case repair how to make AWD into FWD

Подписаться 262

Просмотров 32 тыс.

50% 1

. I bought the 07 Equinox at the Dayton Goodwill Auto Auction as a DNR (Does Not Run) for $300 it needed a battery, back brake work and trans lines. 500 miles later the transfer case went out.. Still ran and drove Great! just a bunch of clanging noise from the front. I couldn't find new replacement gears and all 6 that i found in the junk yard were as bad or worse than mine. I also found that their was not much info out there on the Equinox transfer case removal or repair. so I thought I would share some info on it. This repair took me just over 5 hours and only cost $8. (a bottle of diff fluid) and my AWD Equinox is now FWD and still Driving!! Jeff

Опубликовано:

11 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 26

@prestigeworldwide5538 3 года назад

Caught the very familiar sound at the end of this sweet infovid. I do not miss hearing the wrrrRRRRRRrrrrr of a rear wheel bearing. Thank for sharing.

@ogchris4209 Год назад

Thank you so much I been trying to figure out how to get that transfer case out of there this is the only video I could find that is decent at explaining shit

@jaquintastewartrosegold988 9 месяцев назад

How much would this job cost? Is $2000 for used part and labor too much?

@kcyasharahla3844 4 года назад

You are unique. Your video May be the best one on this issue and i appreciate your walk thru on the issue. I've looked for More info but ours hardly there add its a known issue. Torrent, vue, and equinox. To sum it up.... Thank you very much

@kcyasharahla3844 3 года назад

@Red eyed Patriot1 thank you for this i didn't know the xl7 was in that category✌✌

@zachamilton8104 3 года назад

I have a 2012 equinox. Without pulling the transfer case I pulled the drive line, carrier bearing and pulled the output shaft, seal bearings and all. Then built a plate and gasket to seal it back up.

@carlosg5229 2 года назад

How long did it take you to do it? I’m trying to do the same to my 12 equinox

@wesleyreid3128 2 года назад

this is the idea I got

@vernonbosshard9317 Год назад

I'm doing a head gasket job on my 05 equinox so I decided to pull this unit out and inspect, glad I did, found a bearing race with extensive damage, it was a ticking time bomb. Can you drive out the pinion with a black and hammer? I'm in the process of getting a used T-case so I want to inspect it and install new seals before I go back with it.

@user-ng2se7ke6x Год назад

You said there was a need for that sleeve that the ring gear was on. What’s the purpose. Seems to me the only need for it is reinforcement on the primary shaft and fluid disbursement. Asking because I can’t get the bolts off for the ring gear and debating if I need it at all

@rickbaker9053 3 года назад

Awesome Job

@Tweeze513 4 года назад

THANK YOU, THANK YOU, THANK YOU!!!!!

@vernonbosshard9317 2 года назад

Theres no viscous clutch?

@Random.Adventures. 11 месяцев назад

thanks

@VidScribe 3 года назад

at the end of the video, you reported "no lights", I would reasonably expect that, up until the front wheels spin, Then you would get a combo message to check ABS, Stabilitrac, traction control. But no Engine light, ever, right? After driving for some days trouble free, the computer would reset the error. Have you hade the opportunity to verify that?

@jtmoneygreen7043 3 года назад

Your a genius

@RigoCorrea-dx8bx 10 месяцев назад

I just bought a 2011 equinox. It makes noise with the drive shaft on but it doesn't make noise without it. Can i drive the car without the drive shaft to Mexico? 🤔

@jasonscales2522 2 года назад

My equinox don't have the shaft that you tapped out but it dose have the shaft that comes out of the trans that goes through the transfer case into the passenger side drive shaft. Did you have to remove the steering rack? On mine I can't get it out without removing it. How did you remove the t-case from the shaft?