the bike doesn't half shift with the speed sensors. Roundabouts a bit tricky and hand signals. If anything my left arm feels weird as I am so used to a MTB reach
@@PetersReviews yea I noticed recently looking back gives some gyp on the neck and a mirror can be handy. Then again on a motorbike should still look back even with a mirror. Indicator on an ebike are too small.... Lol, I overshot my front gate.....twice. had to go round the block again
Think what I was trying to say is the acceleration but when turning right and at a roundabout, holding arm out and it accelerates too quick. When riding a normal bike approaching and holding the arm out before and during, the motions are steady. With the ebike it is not quite the same. I guess a torque sensor would be better at it, it's a bit more controlled. Suppose the only way to counter balance is also switch down from assist 3 to assist 2 just before a roundabout. Then again that depends if I have to stop or not and the last thing would need is a slow start from the give way into the outer lane. If it is clear may not have to do much but there is a difference
@@PetersReviews i think what the issue is when approaching a roundabout soon as stop pedalling it slows right down like if the brakes are applied, then start pedaling again and zooms. So when holding the right arm out at this point can be a bit tricky compared to a normal bike
So far, weld spatters visible on the welds and inside the "V" abive the oedal and painted over, a weird creak bow and then coming from he down tube area, incinsistent or sluggish moto in hugher gearsr but zooms faster than a normal bike in lower gears. I swear today when pedaling in 4th it felt like it was dropping power on a flat stretch, then came back up without increasing pedaling in a space if about 4 to 5 seconds. And i still havent seen this at full price...what is going on
@@johnsouthwales1078 Hi there, sounds like the clamp is not doing its job. Quick short video to eskute they will send you a new one if ask them if you can buy one online and be reimbursed.
@@PetersReviews yeah I received it today, I assembled it after lunchtime. There is not much room left to tighten with fingers, wonder if a pliers could tighten it a millimetre more
Oh, I had a look at it again.There is a piece of curved plastic right at the top of the thread. I reversed it so it is facing the other way.. not on the thread itself but just where the clamp squeezed. I turned it to face the other way and so far it seems to worked