I did it and the upload wasn't complete and it gave me the following error. error: unterminated #ifndef 49 | #ifndef ENC28J60 error: unterminated #ifndef 47 | #ifndef WIZNET_W5100 error: unterminated #ifndef 44 | #ifndef Modbus_TCPIP_h How to fix it? Thank you
Hello. Could you help me a bit? I am using the USR ES1 W5500 connected to the ESP8266 via SPI in the same way you connected it. However, when I upload code using Platform IO, I encounter an error and cannot upload it. When I disconnect the power of the USR ES1 W5500, the code uploads normally. I would like to ask how to fix this issue. Thank you.
Maybe One common solution is to disconnect the SPI connections (MISO, MOSI, SCK, and CS) between the ESP8266 and the W5500 module while uploading your code After uploading, you can connect again and run it normally.
@@YaserAliHusen sir presently am using enc28j60. I want to replace this module. I can't found any vdo in RU-vid how to use blynk interfacing with w5500
@@YaserAliHusen Thank you for tutorial...Now I'm able to read data from esp to PLC... Can you please make a video of sending INT & BOOLEAN data from PLC to ESP...
permisi pa bagaimana kalau misalnya esp32 sebagai slave dan laptop sebagai server esp32 bisa memberi write single holding ke laptop/plc untuk menjalankan sebuah mesin dan esp32 bisa read holding hasil dia menjalakan perintah tersebut terimakasih
Silahkan dilihat pada video saya yang lain: ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-ms4VxSzJtVU.html Saya menggunakan ESP8266, seharusnya ESP32 juga bisa. Silahkan eksplore lagi video2 lainnya Terima Kasih