I have servo drive M753 via ethercat connected to Beckhoff. I did the motor setting and autotune via connect software. Twincat scan found the M753. When I set control word to 6 than to 7 than set target position to some value and set control word to 15 it move to desired position. But the problem is speed. Whatever parameter I set, the speed is always the same. Where I can set desired velocity?
thanks for the tutorial. what are the indexes for wcstate, input toggle, and state that you have in the tutorial? cannot find them in the documentation
Please submit a support ticket for assistance. You can do this from our Support page: acim.nidec.com/en-us/drives/control-techniques/service-and-support/technical-support
Please I need Help with SI_canopen module, I have a M700 04400150 Drive and I am trying to \communicate thorugh CANOpen . The CT customer support is not helping even.
