Everything About Car Damping | Car Damping Kitni Zaruri? | Blaupunkt Damping Sheet 3.0 | Eon Car 

Hello Tejaswi, I am glad you liked the video. If you put damping sheets on the floor it will reduce the road noise to the max of 20%, the only way to reduce is an investment in soft rubber tyres. You can go with a brand like Michelin. Soft rubber tyres are easy to cut (damage) on bad roads. Thank you. :)

Obviously the more you invest the better it will be. Apart from damping; silent tyres, quality road and engine condition are also considerable aspects.

Exactly and even partial door damping like he says is useless and WILL NOT give the desired results i have done proper door damping so i know what it means.

@@rajeshr8121 Hi Rajesh, I request you to share the NVH level of your cabin while driving. You can use any soundmeter app. This would be helpful for everyone :)

Yes, it will reduce the flex to some extent.

Well i am not an expert but according to my reading certain articles installer uses full sheets because to earn more. There is a word resonance and that can be obtained by piece installation but the installer should be well aware about where to put and they should have the equipments to measure before n after nvh levels.

@@AtulKumar-ep9cw thanks

Hello, Thanks for your comment. There would not be much difference as compared to the price you pay. There will a slight difference in NVH levels. But the speakers will sound really good. You can feel the mids and lows. Thanks.

Ofcourse, there will be....sound acoustics is not just about resonance it's more about sound insulation and obsorption. There is a reason installers tell you to go for proper insulation and it's not just about money like he says.

Correct 👍

Thanks Yaksh. I am glad you like it. :)

Hello bhai, sheet lagane ke baad almost 2000 kms chali hai gaadi. Sheet waisi hi hai. Achhi sheet lagaiye kuch nahi hoga. Agar test karna hai to choti si sheet laga kar kuch din drive kariye, jab confidence bane to jitni lagana hai utni laga lijiye :)

Jo apne doors par lagaya hai uski video baniye kese lagya ha

Hi Saravana, Thanks for your comment. Hope you are doing great. Can you explain the issue you are facing? Is the cabin noise (engine/road)? or you are losing the bass and mids while driving? or is it some other kind of noise?

@@srizwanashraf Yes Rizwan exactly the word you mentioned here 1.Tire noise (Inside Cabin) In slow speed 40 km/hr and at Highway 100km/hr speed were the road is not smoothen losing the bass from rear & front speakers. 2. Engine Noise (Inside Cabin) This issue I am facing when we drive in city limit and when the environment little quiet. But when the car is stable and windows are closed the music performance good to hear and every sound is clear.

@@perumalsaravana88 Let's start with the basis. Check the tyre pressure and make sure it is the same as suggested by your car manufacturer. If it is only about music, damping alone is not going to help, if you have company fitted speakers you have to upgrade those to Pioneer or Sony coaxial speakers or if you have a budget then go with components. For the extra thump, you need to add a subwoofer. So if music is the only concern, install a sub and that's it. If music and you want to cut down that humming sound while driving, then go with damping and speakers upgrade. 5 sheets are enough if you want to damp the doors. If you wish to damp the floor as well another 2-3 sheets will be required.

Hi Rizwan Thanks for your reference. Sorry for the late response. FYI. I have replaced the HU and rear parcel tray speaker, XAV3200 is HU and Sony coaxial speaker for rear parcel tray as you mentioned. But I feel the Sony coaxial speaker model Fb693E which one i fixed is over rated. Bcz while driving I can't listen the bass. And I don't want fill the boot to fix bass tube from the beginning I am not much interested to fix that one. But yes I go with component speaker to get the same. For the quite cabin I will fix the damping sheet myself from your guidance Thanks a lot for your time given to me for the guidance and suggestions.

Hello, Is there a drastic difference in bass. When engine is off vs engine is on vs driving?

@@srizwanashraf when engine is off then sounds is fine.

@@eonthebeast2300 few suggestions for switching the head unit. 1: Procure 1 sheet of damping sheet from the local market, choose a good brand like Blaupunkt and cut it into parts, and paste it under the hood (bonnet) and a few on the firewall. It should reduce the cabin noise from the engine to a good extent. You can feel the difference. This will cost you between 400-700. 2: Buy 1 box of damping sheets, you will get 5 sheets. enough for the door and bonnet. Damping the doors will increase the quality of bass and vocal. This will cost you 3500 and labor if you can't do it yourself. 3. Install a bass tube. Proper good brands like Sony or JBL. Don't go with those with inbuilt amplifiers. This will cost you around 15K Replacing the Head unit would not be an economically wise decision in my opinion. I suggest you go with the first option for now and you would not be disappointed. PS: If the engine noise is due to a bad engine or due to some mechanical problem, the methods would not help. Also, which components you have got?

@@srizwanashraf Hi & thanks for the reply. I have infinity alpha components in front & rear I have made a box in which sony 320w installed. I am not sure about the specs of Sony coaxial speakers but yes they are around 8-9 years old. I am satisfied with the front speakers but not with the rear ones.

Thank you 👍

Hello Amar, Hope you are doing great! With damping, you cabin is not going to be 100% noise proof. Only 20-30 percent of the noise can be blocked. Damping is more of a music thing. If the noise in the cabin is road noise, adjust the tyre pressure as per the manufacturer's guidelines, if it is wind check the door rubber gasket and if it is the engine check if the oil is in the good condition. Thanks.

engine noise can be reduced by damping the hood and the firewall, check the engine mounting if the vibration is too much. Damping alone won't help much with vibration.

Thanks 😊

Yes bro 😊

Hello, Hope you are doing great! For vibration, you can check the engine mount. If you are going for service, consider flushing your engine. You can put the damping material on the firewall. Check if the hood liner is installed on the bonnet/hood. You can add a damping sheet underneath. There must be some loose/suspending part in the dashboard which is causing the noise. Damping the doors will only make music better and reduce outside noise by 15-20%, not the engine noise. Thanks.

I don't know much of other brands, but seen a lot of RU-vid videos promoting CTK. Please see the quality yourself before going with the brand. But please do not opt for cheap ones. They will come off over the time.

For best output upgrade your speakers, 5 sheets are good enough to the most from the speakers already installed.

If you wish to cover the entire sheet of the door from inside and outside then one door will require 2 sheets. So, total 8 sheets for doors, 4-5 for floor and 3 for boot and hood. If you would like to just put patches like I did then make the quantity half.

Kuch khaas fark nahi padega. Cabin filter ko saaf rakhiye taki airflow achha rahe. Windows pe UV block karne wali film lagaiye, ac ke gas ka level proper rakhiye aur condenser saaf. Gaadi thandi rahegi. :)

Hello Stanzin. Hope you are doing great. Yes, 5 sheets would be enough for doors and hood. Cut one sheet in two halves, divide the one into 3 parts. Paste them on the inside part of the door maintaining equal distance from each. Use the remaining half to cover the holes and cut of of the outer sheet. Let me know if you have any questions. Thanks.

Hello Vicky, asha karta hu aap achhe honge. Aap pehle ek sheet to do part me kaat len, aadhi sheet ko phir 3 barabar hisse me. In teeno ko door ke andar wale hisse me 3-4 inches ke distance me lagayen. Aadhi bachi hui sheet ko bahar wale hisse me jo cut outs hain unhe cover karne me use kare. Ek sheet se ek door ho jaana chahiye.

Hi Rohit. Thanks for your comment. Hope you are doing great! Check if you have hood liner installed under your hood (bonnet) is not, start from there. Let me know if you have any other questions. Thanks.

With out damping we can drive

@@imunknown6262 ????

With out damping we can Frive means???

It is not compulsory in any case. If you are a music lover you can go for it for a better music experience.

@@ashwinkumar2606 it's drive

Pankaj bhai, damping waisi ki waisi hai mujhe lagaye ek saal se zyada ho gaya. Maine blaupunkt ki lagayi hai. Baki companies ka idea nahi hai mujhe.

Hi, Thanks for your comment. Heat gun is not required, these are like stickers. You can simply paste it on clean and dry surface. Thanks.

Hello Viren, Thanks for your comment. The sheet quality is really good. It sticks and holds well and strong. Thanks.

Thanks for your feedback, soon I will make a video in English. Thanks.

give a valid reason please

Hi Rajiv bhai, one can install damping sheet on the hood to reduce engine noise. I have installed blaupunkt's and it is intact. No melting at all. It's been more than a year now.

Yes, 3M Acoustic treatment is also good. Which car you got it installed? Any difference in cabin noise while driving?

@@srizwanashraf ciaz when i got it done and came out of the 3m store i found a difference in sound quality of my atock speakers and after that i upgraded the speakers sytem to components and a base tube now music experience is far better than the stock

Yes, basstube cuts most of the road and engine noise.

Sachin bhai aap bol rahe hain to reseach nahi kiya hoga. Indeed there are different materials available and each absorbs different frequencies differently. The summary or purpose of the video is: 1. Don't use insulating foam as suggested in many youtube videos. 2. Two butyl damping sheet is not necessary for one door. Thank you.

4200 ya 4300 ki sheets aayi thi, baki khud se lagaya hai.

Hello! What is it about?

@@srizwanashraf I own a Hyundai i10 -2010 model. Pre facelift. How many blaupunkt sheets would I need to cover 4 doors, boot, floor and roof?

If you wish to cover the entire surface then, 2 sheets per door. 5 sheets for floor, 3 for roof, and 3 for boot and hood. If you wish to do patching like I did, then make the quantity half.

@@srizwanashraf Thanks a lot!

Hello Rajesh, Hope you are doing great! Thank you for your comment, I appreciate your feedback on this. Also, I would like to add a couple of points to it. Please note, adding a layer of butyl sheet (damping material) will only reduce (a little) the humming noise caused by the vibration of the metal sheet, there are different sound proofing materials available (that will cut/reduce sound of different frequency) which has to be use along with the butyl sheet. After doing all that you see good difference when the car is idle and engine is not running. That is the reason we increase the volume while driving. But when the car is running it is a different case all together because you can not cut the friction between the road and the tires, friction produces vibration and vibration cause the noise we experience as NVH. Apart from damping, there are other aspects which can help in reducing the NVH levels, tire quality, engine quality, vehicle age etc. Find me one RU-vid video that shows drastic difference in NVH level with damping, before and after, using a sound/audio meter and I will take this video down.

@srizwanashraf My perspective was with regards to door damping only, which is done primarily for enhancing the audio quality and most do door damping for this purpose. You have said in your video that it's not necessary to fully dampen the doors which is what is what I disagree totally. I have done my full door damping with high quality damping sheets and my friend has done like here and there damping for his doors with the same speakers fitted and brand of sheets. I have seen the difference was very obvious in the way the speakers sounded and mine was way better than his in terms of audio quality.... So I can confidently say bits and pieces door damping won't work and give the required full results of damping.