Evinrude e tec 30 water pump impeller replacement 

Thank you so much for sharing, I live in Norway. The prise of an regular 300h service including the impeller change is close to 1/3 of the price of a brand new engine. Thank you again, this is very useful.

If a motor sits a lot those vanes can take a permanent set and the material gets hard. Pamper that etec…….there are no more coming. This was a good video. When I was doing thus for the first time, I had to watch 5 of them to assemble enough information. Yours is pretty clear.

So, besides KITTY!, thanks for the video. The tip to use a ladder to support the lower unit was easily worth the price of admission. I would say, the instructions with the kit state to insert the impeller key and slide down the impeller to trap it before mounting the driveshaft. I did it as listed, and it took seconds, just needing a tap on a 2x4 to completely seat the impeller over the key. Secondly, when torquing a set of fasteners, one shouldn't work clockwise or counterclockwise, but in a diagonally opposed fashion. Doing it as you did will allow the housing to flex, and result in inconsistently tight fasteners. If numbered 1-6 in a clockwise fashion, I torqued 1-4-6-3-2-5. I went around a second time, and nothing moved.

Hello, I need help buying pistons and rings for my 2010 Evinrude Etec 25. I'm from Brazil and they're not available here. If anyone knows where I can get them, I'd be grateful.

Thank you for the video. Why were you changing the thermostat? Other springs mentioned?

KITTY!