Few people know how to make steel door panel without bending machine | Welding tips and tricks 

Thank you!!

Muestre el suyo

Thank you!

Для чего этот гемор, стесняюсь спросить?

Thanks bro!

Эта херня для декора ворот?🤦🤦🤦

Thak you

Your welcome!!

Thank you i appreciate it

Siempre es igual, pudieras aumentar de los 5 cm pero a mi gusto, siempre hago las charolas como el video

It’s obviously not a training video, some foreigner just wanted to show off.

Por dentro solo se cubre con lamina y las uniones se cubren con pasta automotroz

Thank you👍

1 1/2”

Great!

Yes

Calibre 18

@@ingeniosinlimites3071 gracias!!!!

20 or 18

Perché da ogni lato del rettangolo prendi 2 cm in più, uno per i doppi da 1 cm e 1 cm per il rilievo, una volta con le due pieghe hai la calza originale in modo che entri esattamente all'interno del rettangolo, ti piacerebbe solo senza la tab. 1 cm dovresti aggiungere solo +2 alla misura originale

Las uniones de la parte del hueco las resanas con pasta automotriz y queda muy bien pintada!

Metric uses fractions too buddy. It's just read as a decimal

Parce que de chaque côté du rectangle tu prends 2cm en plus, un pour les 1cm doubles et 1cm pour le relief, une fois avec les deux plis tu as le bas d'origine pour qu'il rentre exactement à l'intérieur du rectangle, tu ne l'aimerais que sans la languette. 1 cm il faudrait ajouter seulement +2 à la mesure originale

Karena ketebalan bingkai 4cm...klo ketebalan bingkai 6cm maka tambahkan juga 6cm

1 1/2”

Why don't you look for those which are editted

Some of us appreciate the step by steep, mark by mark and cut by cut!

If he had just done that, there would be 50 comments asking for measurements.

You have so many options… for example just simply skip the part you dont want to spend time on or just to look for another video… It is not how we appreciate the effort the content creator put in

If you are an expert, why don't you make your's and we learn from you?

Имитация филёнок Ворота входные