FFLP VS RAC X VS LP Graco Airless Tips Pros, Cons, and Comparison of Each Tip 

There's still air in the line I usually run it about a minute before I start spraying

This poor dude didn't even tighten the blue tip guard all the way down. It's leaking past the seal because it's loose. It' s clear he's well versed with an airless because of how he's got the tip guard on nice and crooked hahaha

@@lotuselise5000 Much more plausible than his answer.

Air in the lines does not cause dripping... a loose guard, or bad gun needle will do that...

He's just a messy youtuber who hasn't a clue what he is doing...

Step down transformer

I also have the same question, i think the motor should be replaced to 220v but not sure about that

To be or not to be, that is the question. All professional Graco pumps are 110v, which is just fine in America but lagging double the weight of the pump with a mandatory transformer is a real pain in the butt. If you notice, this Graco 390 is in fact a Dewalt battery powered unit. Which costs about £500 more (lots of that is the cost of batteries, charger and a brushless motor) but then you will NOT have to worry about 110v transformers...

615 or 617 regular tip.

Hi both the yellow and green tips use about the same psi 1500 is the low end you can increase psi if you notice your not getting good atomization

Hey we have been around a long time but a bit under the radar my name's Patrick I am in the video my line is 412 598 5738 feel free to call anytime

fflp perfect for all, you just look haw match paint going with 517 and 514 , make 514cwill bw better, can use less paint

Fflp but lp would work too and depends what product you’re using and the size of roof and how much you want to get done at a time, if your new to spraying I’d go with a smaller fan which would be a 4/15 5/17 I’d at least use a 5/17 and up on a roof tho

enamel paint

Yes

Yes and the tip seat is also smaller and put a red mesh filter in your gun

Yes it would help a good bit

Hi depends on the paint product you will end up using but in general I would consider a low pressure tip

Exactly you can't go from an LP tip to an FFLP tip without changing the tip seat and a tighter mesh gun filter or you will create plenty of problems and stoppages

This was a terrible video all the way around to be honest

@@johnthemod71 I have come back to this video and was going to comment that, lol it’s wild

Take a guess

@@TheEpoxyExpert you are a lot of help

@Travis k which tip did you end up using? And how did it turn out? I also have interior doors to paint and just picked up a Graco sprayer.

@@pepperiv5652 I got rac x fflp. It worked great

@@travisk5589 Thank you so much for the quick reply. What number tip was it? Was it a smooth finish? Did it have any texture? Thanks again!