Filing nails! How to give shape to nails! Nail extension!
In this video we learn how to create the correct shape of nails when building nails.
#nail #eva lorman #nailextension
We will consider sawdust square salon
option.
Measure length and shape
free edge.
Clamp the side rollers of the client's finger
so that we could only see him
nail. This way we will not damage the skin
client's.
In some techniques sawdust
this line is called line number 2-line
free edge.
The correctness of this line is checked with
the inside of the free edge.
The first line is not sawn, it is visual
finger axis, which runs along the finger
and does not repeat natural curves
finger's. 3 and 4 lines - they are almost the most
important, precisely they
a clear form is created. For this are posing
nail file on the edge and movements on themselves, without
change of direction, sawing with one and with
on the other side of the nail, while watching the
thick on the sides-it should not be
less than 0.5 millimeters on both sides.
Otherwise it may open up the natural nail
and in this case will have to report
material. These lines should be
perpendicular to the second line and
parallel to each other.
5 line is a line along the contour of the cuticle.
It must be sawn so that the material
retreated from the cuticle at least
one millimeter, otherwise there will be a detachment.
In this zone should be the thinnest
a layer of gel. Filing this area should be very
gently, otherwise you can damage the skin
client's. It is best to use a saw
at least 180 grit. 6 and 7 lines-they
remove the formed faces after sawdust
third and fourth lines. The sixth and
the seventh line we remove these faces
removing the angular surface.
The correctness of their sawdust can be checked
pressing on the free edge of the nail-it is from
it doesn't have to bend like it does
at the same time, a natural nail.
The thickness of the gel on the sides should not be
less than 0.5 millimeters. Filing
these lines we round off as it were lateral
the sides of the nail. 6 and 7 line should be
between themselves are symmetrical.
The eighth is not a line,
and the highest point is on the nail.
It is in its place
depending on the length of the free edge.
If the free edge is less than the length of the nail
plate, then this point is
the center of the entire length from the cuticle to
the end of the free edge. If the length of the
free cut the same as the nail
plate, then 8 point is on
stress area, the area of the nail smile
plates. The ninth is not a line, but a zone.
Mentally find 8 point and from it in
side of the free edge apilevel area,
which in the end should create a smooth
beautiful arch from the free edge.
We check applying a file on 8 point and
look at the end of the nail.
All the hollows and bumps are very good
perhaps they should be sawn off.
10 line-this line aligns the side
part of the nail
under one level. With the right sawdust
the thickness of the free edge
the cross arch should be about 1
mm. If it turned out more, then
can be cut from the inside with a cutter with
nozzle cylinder.
As a result, after the correct sawdust should
get a form that repeats the form
natural nail,
but at the same time have the thickness to nail
did not break in the process of wear.
But it should not be too thick and
all the more necessarily smooth. We are with you
considered the main lines of sawdust
square in the salon variant of the build
nails'.
Eva Lorman was with you!
Subscribe to my channel!
/ evalorman
Leave feedback!
Put huskies! All the best to You and good luck!
17 апр 2015