First run of the Husqvarna 365 race saw! 

Good to see Soft hands Steve handle that gem with care.

Boedy quote of the year “fresh out of the box C83 chain”. The saw looks like a real ripper! Maybe use your temp gun to get some readings. You know for “Science”.

I wonder if adding a priming bulb on the fuel line would make cold starts easier.

Now That’s a Raging Screamer and Ripper 😀😊😀❤️❤️❤️ Love That Saw It’s Like a Hot Knife In Butter 😀 👍🏼👍🏼👍🏼👍🏼👍🏼👍🏼👍🏼 Seems Like a Little High Speed Adjustment and Your Good to Go

You've got to put the tree felling fail back in the intro, it was hilarious!

Awesome new intro dude!!!

AWESOME!!!!! More! More! More!!

I bet it fouls plugs often if you dont have it tuned perfect. Would be nice to know the tuning rpm and maybe read the plug to see where youre at. Cheers. Its a ripper

Sounds crispy!

Have you fixed the carb problem?? I would like to see it cut when it's done.

What carb does it have? The Walbro HDA199s on the 359s were a PITA to keep running right. Guessing it's got a bigger carb with the port work though?

Wihh mantap betul itu chain Saw husqvarna 🔥👍

Loose bar nuts?? Bar looked like it was jumping around alot when the power head was stable on the log and you were on/off throttle

It’s a screamer for sure

Is your chain getting bound up or maybe an oiling or clutch issue

Extra special 😂 so good

She’s definitely a ripper for sure.

That first cut was just stupid fast!!!

Is it oiling that bar at all!!????

I'd drop a new plug in it, I struggled with my Poulan last spring and it was acting just like that, new plug fixed it. It had great spark and wasn't fouled but it ran just like that. I swear my great hairs multiplied lol

Let us know what the issue was.

Hope you figure it out. Seems like a lot of carb a tooter for that saw you could stick two fingers in there. But man what a ripper.

Go Stevo Go

All that yanking on the starter isn't going to help that elbow. Have a great day Boedy.

Once you open the ports so far you lose low rpm velocity, hence the hard start. The same reason a huge camshaft lopes at idle. In a 4 stroke.

Go to a hobby shop or look online for a nitro RC car fuel filler squeeze bottle. Traxxas brand is what I use to squirt fuel in carbs.

Remove the plug Dry out the plug Pull the rope many times to clean out the fuel in the motor Dry out the fuel and plug Get a new clean dry plug and put back in the Saw Ant Saw that has work done into a mod hot Saw Will flood much easier

Hebat sekali mesin nya kawan

I like the intro. That thing is spitting the chips along way and out of the field of view of the camera. You will have to buy a wide angle lens or position the camera further back 😂

You got lucky not to flood out your Saw When putting fuel in the carb PPE in running that mkd hot Saw

👍

Fuel / oil mixture?

👍🆙BigGuy

Probably wrong heat range on plug too.

Boy she sure does scream! I know it's difficult to impossible to tell through the camera but almost seems lean to me.

Let's hope you get it right😒

Is there any slack in your chain whatsoever?!!! Chain was super tight and you just expanded your bar and locked up your chain????

Piston’s swollen up!!!! Stop and just let it idle for 3 minutes!!!!!

Way way way too much reving cold!!!!!!

First