Fixing a Throttle Trigger on Stihl MS 261 Chainsaw

Подписаться 81 тыс.

Просмотров 23 тыс.

50% 1

In this video I disassemble a throttle trigger, clean the throttle pin, and reassemble it on a Stihl MS 261 chainsaw. This process works with a Stihl MS 250, MS 251, MS 270, MS 271, MS 440, and MS 660. It should work with all Stihl chainsaws. Thank you for watching our videos.
As an Amazon Associate I earn from qualifying purchases from the following links.
The best knife and tool sharpener: amzn.to/3z8P1vu

Опубликовано:

17 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 22

@geologistsavant Год назад

Thank you for an excellent video, close enough and very clear what you had to do. You can tell you have work to do you were right to the point...I didn't get your life history...and you knew what you were doing going into the repair so there were no fumbles, oopses or unnecessary moves.

@DowdleFamilyFarms Год назад

Thank you. I hope it helped you!

@JamesThomas-fk3hu 3 месяца назад

Thank you, had this exact problem on my 661 and this has got me going again, I’ll still replace the pin with a new one when I get one as I’m sure the old one will rust again quickly

@DowdleFamilyFarms 3 месяца назад

Thanks for watching.

@billbezzant3033 Год назад

Perfect! This is my exact problem on my MS-261CM and now I see how to fix it. I would have started disassembling from the wrong end if I hadn’t seen this video. Thank you!

@DowdleFamilyFarms Год назад

Glad it help. Just out of curiosity, how did you find the video?

@alfredopampanga9356 4 месяца назад

That’s not the only reason. See my explanation elsewhere in comments

@ArveJoh Год назад

Thanks for that. The opening mecanism was all I need.

@DowdleFamilyFarms Год назад

Glad it helped!

@BobWeave 8 месяцев назад

Also works for STIHL MS291. Thx a bunch

@DowdleFamilyFarms 8 месяцев назад

Anytime. Thanks for watching!

@rrjnelson5244 10 месяцев назад

Same thing happened to my stihl thanks a bunch for the information

@DowdleFamilyFarms 10 месяцев назад

Glad I could help. Thanks for watching.

@alfredopampanga9356 4 месяца назад

The real reason is the throttle linkage rotates about a 90 bend. There’s a slot where it lies When the linkage jumps out of that slot you get sticky trigger

@DowdleFamilyFarms 4 месяца назад

It’s hard to know precisely what you are talking about without looking at it but I think I know. The problem on this one was a corroded pin though. That whole trigger twists on the pin.

@alfredopampanga9356 4 месяца назад

@@DowdleFamilyFarms Yes, I understand what you are referring to. But there’s a general problem with MS311 and its relatives. If you look at where the throttle linkage sits in a cradle , just past the pin , you will see it pops out sometimes. It is this that causes the problem.

@DowdleFamilyFarms 4 месяца назад

I see.