Flex Innovations Super PNP Series - Basic PNP Model Setup 

Flex Innovations Super PNP Series
This video shows you how to setup a basic Flex Innovations Super PNP model.
All of the products used were taken right out of the boxes and connected to show you how easy it is to setup a Flex Innovations Model. We will have more advanced videos in the future that will cover more advanced topics.
*FOR THE FOLLOWING STEPS MAKE SURE THE PROPELLER IS NOT INSTALLED*
Aura likes to see a basic Model in your Transmitter (1 Aileron, 1 elevator, & 1 Rudder). Make sure that your Aircraft type has the Wings and Tail set to "Normal" then you can move on to setting up your servo travels. Go into the Servo Setup Menu and make sure that you have the the travels set per the manual.
Assign a 3 position switch to channel 5 for the 3 Flight modes assigned in Aura. At this time, confirm all the flight surfaces and throttle are working and moving the correct directions.
Install the propeller and spinner and proceed with your Maiden flight. Trim as needed and follow the "Quick Trim" steps shown in the video.
QUICK TRIM:
1) Land the airplane in mode 2 and do not power down the Transmitter. Power down the plane and remove whatever servo wire is plugged into Port S3 and replace it with a BIND PLUG.
2) Keep your Transmitter powered on and leave the flight trims alone. Power up the plane with the BIND PLUG in Aura port S3...Aura's blue LED with begin to flash SLOW. Remove the Bind plug from Aura, this will make the blue LED flash FAST.
3) While the blue LED is flashing FAST center your Transmitter Trims and plug the original servo wire back into Aura Port S3. Power down the plane and that completes the quick trim process.
What kind of Videos would you like to see?
Leave a comment below!
Subscribe!
www.youtube.co...
Facebook: / flexinnovationsrc
Instagram: / flexinnovationsrc
Twitter: / flexinnovations