FM 200 FIRE EXTINGUISHANT AND SUPRESSION SYSTEM 

BON À ENTENDRE ET MERCI POUR LE COMPLÉMENT

VA FAIRE DES SOUS-TITRES FRANÇAIS QUAND IL Y A PLUS D'ABONNÉS FRANÇAIS LOL

if what you saying is activating the manual release then its yes it will release in zero secs

it is possible but to check the activation of the solenoid wont be applicable, and you have to get another EOL to normalize the panel..

solenoid is supposed to be hand tightened not with a spanner

you can message us directly

​@@engineersguide4249please share your email, very helpful demonstration

You need to reset it by pressing the processor reset button below the key enable switch ... Just give me a feed back after it's done ✅ TNx

@@engineersguide4249 press reset when the alarm sound is working? Or first I clean the detector and then press reset?

You can only reset when the system is not in discharged mode ..but if it discharges u need to hard reset by resetting through the pressing of processor reset

@@falcond214 you can silent the system, clean it then do the reset to avoid continuous alarming

any where just above the union at the cylinder and for the panel side tell me the kind of panel you are using

NO WORRIES JUST TELL ME THE ISSUE AND WOULD BE GLAD TO HELP YOU OUT ..FOR THE TERMINATION ITS JUST CONNECTING IT TO NORMALLY OPEN WITH YOUR END OF LINE RESISTOR FIXED

It's always advisable to get a relay when u want to connect any fan or damper