STL- fab365.net/ite...
In response to numerous requests from customers, I designed the F-22 Raptor for 3D printing.
STL- fab365.net/ite...
The main features are:
1. The missile hangar can be opened and closed.
2. The angle of the wing flaps can be changed.
3. The angle of the horizontal tail wings can be changed.
4. The angle of the thrust vectoring flap at the rear of the engine can be changed.
5. Landing gears can be equipped.
Precautions to be taken when printing and making are as follows:
1. When printing wings, it is recommended to use a brim so that it does not fall off the bed during printing.
2. If the brim is not cut accurately, the parts may not fit well, so please remove the brim carefully.
3. The flap of the main wing is not designed to move, but is designed to be attached to the user's desired angle.
4. Hold the thrust vectoring flap at the rear of the engine with pliers and turn it into place.
1 : 72 Scale
Largest part in printing, size = X 93mm, Y 130mm, Z 132mm, After full assembly size= X 194mm, Y 263mm, Z 73mm
5 окт 2024
