Ford Fusion blower motor resistor and pigtail replacement

Подписаться 954

Просмотров 5 тыс.

50% 1

I was asked to take a look at this 2011 Ford Fusion and figure out why the blower motor wasn’t working. I took a look and found the resistor and wiring harness to be bad. Here’s a look into my diagnosis and repair. Enjoy!
Have anything you’d like to see? Anything you like so far? Ideas for the channel? Let me know.
Subscribe for more!
Channel Instagram: / mpt.yt4
Facebook: / michaeltomko4
Snapchat: / michaeltomko4
Reach out: mpt.yt4@gmail.com

Опубликовано:

7 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 22

@aaronota939 22 дня назад

I looked at about six other videos, that were i strumental, but yours was the golden ticket. As i unplugged things i would replug then turned the ignition to start the system, and WALA. It worked.

@cowboy26a 24 дня назад

Wife's 2011 Ford Fusion. Blower motor would quit and then restart . I replaced the blower motor and problem still persisted. Watched your video and when I pulled the blower motor resistor I found the same problem. Burnt plug. I could wiggle the plug and the blower moter would run. Ordered the resistor module and plug pigtail. Your video save me a lot of trouble shooting.

@mpt.yt4 24 дня назад

Glad i could help!

@markgarduno4597 6 месяцев назад

Explained clearly and direct to the point. Thank you sir.😮

@aushaleflowers5890 29 дней назад

This is a great video.. Exactly what I needed

@williamcreery2631 7 месяцев назад

Very informative! This Definitely gives me an insight on checking and replacing my blower motor! Thank You!

@mpt.yt4 7 месяцев назад

🫡🫡

@KaoticGhoul640 2 месяца назад

You are a lifesaver, thank you so much for the tutorial, I have AC again!!!

@mpt.yt4 2 месяца назад

Glad to help!!

@danielj1063 7 месяцев назад

Nice work, esp catchin' periferals Thanks

@mpt.yt4 7 месяцев назад

Thanks!

@25rangebomb 13 дней назад

👏🏽 perfect video, thank YOU

@mpt.yt4 13 дней назад

You’re welcome!

@386DAWG 11 дней назад

Ford Fusion blower motor resistor and pigtail replacement

@noviye6 Месяц назад

That was really good

@sebastiansebastiansebastia1076 Месяц назад

Goat

@LucidVisionMane 5 месяцев назад

Hey do I need to disconnect the terminals for this? I hear 50/50 from everyone so just wondering if you left them connected.

@mpt.yt4 5 месяцев назад

Not sure which terminals you’re talking about, but I only disconnected what I showed in the video. I had to replace my plug end because of how melted it was.

@LucidVisionMane 5 месяцев назад

@@mpt.yt4 oh I meant if I needed to disconnect the battery cables before doing this but it’s all good, I had opened the resistor kit and it ended up being the first step on the instructions lol.