[Freed Plus] It was too cozy to use that function... [Luggage board homebrew] 

It was Freed Plus luggage board making.
This is an introduction of the parts used this time.
There may be a simpler way to make it, but for reference (^ ^) /
Please comment if you have any questions.
・"Color shelf" size 1800 x 16 x 400 (mm) ... 1 sheet
・"Stainless steel hexagon bolt" M6 x 40 (mm) pitch 1 mm x 6
・"Stainless flat head screw" M6 x 25 (mm) pitch 1 mm x 2
・"Wing nut" for M6 x 2
・"Stainless steel stay" (L-shaped metal fitting) For M6 bolts Long side 69, Short side 44, Width 20 (mm) *It is recommended that the hole position has play.
・"Non-slip sheet" purchased at 100 yen
[Wood processing]
* How to make a top plate
① Cut from both sides of the color shelf board by 50 (mm). (Two)
② Drill a hole with a diameter of 6 mm to match the nut spacing of 1250 (mm).
③ Stick anti-slip sheets on both sides to prevent scratches when attached to the vehicle body.
* How to make a top plate
① Create a sample with imitation paper
② Long side cut at 1275 (mm)
③ Cut the corners to match the imitation paper
④ Check the connection with the L-shaped metal fitting and make a hole (6 mm)