Freightliner DD13 "power loss" here's what fixed my problem😵 

My freightliner 14 DD15 does not go pass 55 and gauge reads at 70 then it stops working. You think it can be speed sensor or program my cpc4 since i replaced it after stolen one.

@@ivanivory3366get your cpc reprogrammed at a dealer and have them update all your modules as well.

What code came up on your dash before you replaced the delta sensor?

Man that shit wasn't no joke.. easy joke turnt into a whole week of work and that wasn't even the problem

@@GtPRiCH Hi, did this resolve the issue?

@@EASTCOASTIMPERIAL did you watch the whole video

Good catch

Take the turbo of last... it came from harbor fright

@@GtPRiCH Bet.....appreciate the response

😭😭😭😭 sams club frw

@@GtPRiCH my ninja 👌

What's the code reading when you look it up?

Were you able to fix it?

So brother what fix your problem because im having same issue

@@amanjotsingh2686 i needed to replace dpf filters. Were clugged. If you haven clean them in the past 2 years is always a good idea to do it.

V-POD

@@GtPRiCH thanks

@@GtPRiCH Thank u

No

Yup

Watch the whole video and check out what I replaced..

I have same code, could not find the problem. Please lmk if you figure this out

I have the same problem and can’t figure it out

Have you tried the air intake manifold? That code is saying the manifold is low.

I changed exhaust manifold

change crankcase filter

No I didn't.. this my first time working on it

No

Did u watch the whole video lol

Yes

At the end i saw it running i got the same truck i have loss of power change the 3 things maf flow sensor,the othe sensor and vpod but code 411 pops up is asking for maf flow sensor calibration

I deleted the. Def im located in phx az where you at

All together

Mines doing the same thing. Even with an empty 14000 lb tandem reefer. Mines rated for only 435/1550 but still should haul an empty no problem. Only light on is check engine. Your problem get fixed by any chance?

Mine does same thing. Mine is the 435/1550 rating. Did you find the issue yet?

@@EZNowTruckercheck the air to air flow to see if it’s cracked. I had to install a new new turbo and that helped some but my issue is still there. Just have to pick the right time to put mine back in the shop but my mechanic said that might be the problem. Installed new software to increase the horses to 500

@@EZNowTruckeranother thing g I had my DEF deleted when I first purchased the truck. Not sure if you did that or not but… my turbo had a hole in it so it did increase the power but still not where it should be. My 435 hp truck pulls like a champ but not this 450hp one. My 2 trucks are 2013 and 2014 models DD13. Once I get the issue resolved I will definitely let you know. Good luck until then and check that air to air flow