Problems I've had; 1. Da/dda/dla/dra pieces have no middle hole for complete mount of dba pieces for doors. 2. Screws to mount middle and end caps are not long enough. 3. Much of these cheap metal pieces are warped or slightly dented. In general, aligning all holes were not easy. Maybe tempting to save some money and get this cheap solution. But my suggestion is; Save up a few hundred more and buy something better, and that doesnt leak. This shed sucks and is a pain to build because the metal fabrication is so poor.
Ok so just getting the base to line up was a huge pain.... Now im on step 3 and sooo confused.. At 2:14 in the video it shows putting K46-3 OVER the top of the sides. And yet later they zoom in and show it going on the inside of the corner pannels... which is it? Instruction pictures are extremely confusing, and it is impossible to tell which it is. And I am finding if you make a mistake with the F1 screws and you remove them, they basically strip out the holes, so when putting them back in they are loose.... and thats happening even when not screwing them all the way in while you line everything up. So one small error in placement basically compromises the structure. I have to say i looked at more expensive options at Lowes and expected this to be a bit on the light side but this is a bad design and terrible Instructions 😕