Garmin Kraken LiveScope Bracket installation

Подписаться 38

Просмотров 2,2 тыс.

50% 1

in this video we do a complete teardown of the trolling motor to install the coveted Garmin Kraken live scope adapter bracket
If you're interested in getting any of the gear showcased in the video please head over to our website
www.markemcatc...
like and subscribe for more content, we will be doing more installs and how to's as we transition into ice season

Опубликовано:

30 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 12

@ThomasShue 4 месяца назад

Cheap bastards at Garmin should include this bracket and foot pedal for $4000

@TheonlyDrp Месяц назад

Nice job. I’ll be doing this later in the summer! Thank you!

@ThomasShue 4 месяца назад

2 comments. One filming vertical SUCKS! Two, at 5:00, before you pull the cables, you should attach a thin piece of bank line or string to the cable ends so that when you pull the wires out of the shaft, you can easily pull them all back through. Thanks for the information.

@levonluther9494 4 дня назад

I didn't have time for the full edit too busy riggin! I learned after a few of these if you just save a few extra feet of LiveScope cable it's way easier

@TheDeltalima21 Месяц назад

They mounted this too close to the trolling motor head. It interferes with the transducer and You’ll notice fish disappear as they get closer to the boat.

@glenndaugherity6187 5 месяцев назад

Where’s your shop located ?

@levonluther9494 4 дня назад

Sorry I didn't get the notification on any of these comments... Lapeer Michigan

@jerryschisler5766 9 месяцев назад

You referred to everything comes with the kit, when you buy the livescope bracket for 129. Is that the kit? Or is there another kit you need to buy?

@netgear197 9 месяцев назад

Hi, very good tutorial! Quick question: Does all the gaskets, grease, etc. comes with the braket or you need to buy a separate kit for those? Thanks!

@timgrzybowski8800 7 месяцев назад

Your thoughts on cutting down the shaft to 56”

@phil-1115 6 месяцев назад

I had the same thoughts. My question is about the cables with the plugs. You can't cut those down and you are going to have extra sticking out. My last Motorguide was 54 inches. This Kraken is too long. The other question is, will cutting the shaft void the warranty?

@ThomasShue 4 месяца назад

@@phil-1115buy a replacement shaft and cut it.