Gen2 Modular Lack Drawer System 3D Print for Ikea Lack Enclosure 

Nice job! I do think people don't stop to think that these Lack tables are made of honeycombed paper and that over time screws (especially the typical wood screw) will not hold any but the most trivial load in the long term. To mitigate you can fill the screw holes with lots of glue (though might take a long time to cure dependent on which glue is used) or better yet glue thin plywood to bottom of table and mount through the plywood with something like MDF screws that have deep threads intended for low strength material. The drawer design is great though- is just the table mounting that I have reservations about.

Hi Jarri, thanks for drawing that - I've been looking for a long time and was close to drawing something myself... but it's no longer necessary since you've done the job! One of the very few models that I download from the internet, so you did an excellent well. Very good job - thank you very much!

WOW, you have put really a lot of great thoughts in this system! Amazing!!

These are really well thought out and made.

This is an awesome design. I've had an extra Lack table that I haven't set up yet and am thinking that I'll see it up to get myself some extra storage space.

This is incredibly well thought out, thank you !

Fantastic job. Very impressive.

This is an awesome design!

excellent design...everything is very well thought out!!

I wish I could like this video more than once.

Fantastic stuff!

What a Great design..👍

Love those Ryobi battery holders

Great stuff

like just for the test prints thank you

Damn Nice system

A file for threaded inserts would be great

cool but fyi there is absolutely no *need* to pre-drill something like that. pre-drilling is to prevent splitting. That particleboard wont split.

There's a few places I would love to use these but doing so would end up wasting space because those spaces have a deeper space available to use. I would love to see a way to support double-deep or any-number-deep drawers by locking drawer and drawer cases together front-to-back to create a long drawer.

Awesome

Love this. Have you thought of making this wall mountable? especially for the small drawers

Delicious.

May give this a go, especially the tilt bins. I am in the process of a contractor work van build. Any future plans of making the bins and/or drawer lockable? I know I can do rubber bands or bungie cords, but that would make these beautiful bins rather ghetto looking.

How do the drawer stoppers work? I was assuming they are to stop the drawer from getting pulled all the way out. But they don't seem to do anything with my installation. Any additional guidance will be appreciated.

Great model, just printed out one to test around my shop! Curious where the "drawer stoppers" go? I believe they pop into the base of the drawer case, R and L perspectively? Does the flap stick up or down? Thanks!

Wow, awsome design, I’d hope I had a 3d printer 😢 Greatings from Sweden

did you print them with PETG?

have you thought about making a adaptor for mounting the lcd outside the enclosure?

I appreciate the work that went into this design but I have to say that the tolerances are a little too tight. I realy have to work to get these things put together. They are definitely not as simple as they appear in the video.

Ikea „Lack“ table are made from paper! No need to drill it!

Tis is very very nice, but would take a year to print them out on ordinary printer :-)

Just bought a 3D printer (my fault) with the idea to make exactly like these things.... Then I learned the hard way.... printing this stuff will take months.... what a waste.