Generator Governor Adjustment 

Merhaba.benim bu kol kendi kendine gaz veriyor ve ileri geri gidip duruyor sorun karbüratörden mi yoksa bu kol mu ?

Mine doesn’t surge anymore but it idles super high … even on low

Hello, my onan microlite 2.8k stays in open throttle. It wont start unless i manually close it. Then if i release it, it will go full open throttle again and shit off. Any help will be appreciated

My generator start running but shut off by itself, does not acelerate, and that part is like stuck, do you think thats the cause , maybe I need to adjust that part?

Do you know what the difference is between the 1 and 2 spring positions on the governor arm I have also seen them stamped H and L

my gx200 has another spring that connects to the governors lever; only Im not sure on the other side if or where it connects to the speed control lever..other engines seem to be different

Are you nuts?

In my generator pcb item doesn't work What i can do ?

You have to take off the damn fuel tank to get to the governor. Then to remove a bolt holding the fuel tank in, you have to remove the damn throttle assembly. Then there's a giant gap between the back flywheel cover where bolts can randomly fall in if you're not careful. Horrendous design. But thanks for video. It worked in the end.

Excelente video, simple, and straight to the point...

Simple,easy,professional! Thanks a lot bro!

Drop the music and give more detail information

Had a new carb and fuel tank. This solved the problem!!

I tried this last night and my bike took off so fast it broke the cableholding it to a pole. Idk what i did wrong yet

Thanks very much!

Thankyou for your help and God bless 💯❤️🇵🇬🇵🇬

Thank you for this video. This is the simplest and well presented set of instructions. Good work.

But after adjusted the governor to the normal place but what can be the causes if the governor doesn't return closed to the carburetor during the on speed and it always consume fuell when the engin governor function in that way especially 3000gen, 2900,8000 8800, 8990gen

I would like to ask if this will work or same procedure on 1000W common small generator? Because I have problem with mine. After cleaning the carb, maybe I accidentally hit that thing when I turned back the carb. And the result, super high rpm with over voltage. I tried to adjust the screw but it didn't work. I think, that governor is the problem? Please help me.

Where can I buy governor spring from p3 power generator

Simple effective and practical, thank you!

Thanks..ill try this on my generator for it is super high on rpm making lots of backfire

Thank you very much engineer ❤ love the explanation

Am electrician said i needed to adjust my governor, hence my watching videos trying to identify, but what does this do?

Well done couch.fixed my pump.

Gernter repair kia head aur block repair kia pr start kick 5 baar pr hota aur kbi smoke start me deta hy kya waja hy?

Thanks mate you save my day

How do you know when to adjust it

Thanks

it worked!

Very straight to the point. Thank you for the help.

Will this work for a Robin Subaru EX13 engine on a Coleman Powermate1800 Pulse EX?

Very simple, fast an accurate. Very nice video.

So before the adjustment the throttle was stuck wide open ? Just making sure

I watched this video then went to go do it myself and I messed it up to the point where when I took it off the choke it reved to the moon but I came back later and re-watch watched it and I payed more attention and now it worked lol great vid

What about the Philips head screw with the spring around it, what do you do there.

Nice simple, correct video !

Good