Can you tell me what settings you used with this wood, since it's not Glowforge's Proofgrade material? Also, I'm very new to the Aura and you give very good explanations. I enjoy watching your videos.
How do you get Aura to work consistently? Always seems to have problems. Cuts through then you try to cut the exact same thing and it doesn’t cut through
I always double-check my settings between prints and if there are any failures it's because the software didn't seem to keep my settings between prints, which doesn't seem like an Aura problem. As long as I'm using the same settings I've found it to be extremely consistent.
I agree with Tiara ^^ Double check that you have your design set to Cut and if it doesn’t cut all the way through, you can up the Power or # of passes too. The Aura can have some trial and errors when using different materials! Hope we helped a bit!
Hi Rachel. Was wondering if you can cut this same design using the pass through making one continuous piece using a longer sheet of basswood like you did for the base of your gnome design? 😊