No video :(

Gm 4 speed internal slave cylinder install (mistakes were made)

Подписаться 2 тыс.

Просмотров 19 тыс.

50% 1

Follow the hackery on Instagram @Boostmonger_jon
1978 280z. Aluminum 5.3, np440 4speed.
Well guys i caved and got myself an iternal slave cylinder. If it works as good as it looks im sure i will be quite pleased. (EDIT) follow the manufacturer instructions! I did not put enough shims in.

Опубликовано:

15 апр 2018

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 21

@krispittman1110 5 лет назад

You should really add all your Part Numbers you bought in the description! nice vid though.

@DeMan-1032 2 года назад

You need between .100 and .150 of clearance as the clutch wears the fingers or forks move towards the bearing. The bearing should NOT be turning when you release unless you enjoy replacing it often. You cannot preload the diaphragm of the pressure plate, ever...

@Boostmonger_Jon 2 года назад

Yes. I didnt realize when i put it together. Has been corrected

@mcbridemotorsports5788 2 года назад

I personally would have went back and put a 90 or at the very least a 45 on that bleeder line just because I worry about rub through and I hate redoing work.

@EasyPeazy-wf4ck 4 года назад

WHich trans are you running

@benjohnson3700 3 года назад

use right angle fitting

@johnpowers4348 Год назад

So what bell housing are u using

@DragonsTaco 5 лет назад

How did this turn out? It seemed that you spent little time adjusting the clearance. Looking at speedways directions it said to have .050-.100" clearance, which is not at all what you said in the video. Did you have to reset your clearance?

@Boostmonger_Jon 5 лет назад

Oh interesting, i think i got my specs from another channel. But as of yet its still unfinished, so i may very well have to reset it.

@wasian4 Год назад

Does that throwout bearing bleed ok? I oriented mine as upward as possible to let the air travel upwards to make it easier.

@Boostmonger_Jon Год назад

Yeah it bled quite easily. Works great!

@alvinfisherii1341 Год назад

Do you have any update on this install? I had this set up trying to do it with a Muncie 4 speed on an aluminum 5.3, and Im curious to see how you adjusted it after the fact

@Boostmonger_Jon Год назад

I actually havnt adjusted it at all. Probably could take a shim or 3 out of it. Not enough pedal free play