I know very little about sump pumps, and the instructions included with this one offered info only an expert would appreciate. Thanks, jaykay18, for a thorough and efficient explanation of how to set up this little beast. Hoping the auto-on can save my basement from a rising water table in the upcoming rainstorm-on-top-of-snowstorm. You're an excellent teacher.
@@jaykay18 I'm having a horrible problem with this pump. The housing leaks. It sucks the water up and then it all flows back out thru the housing. What's wrong?
@@smidgenmom There are no surprises with this, it goes together exactly as shown. If there is any water leaking or spraying out while the pump is on, a seal has not been made. If the water flows back when the pump shuts off, either you didn't install the backflow check valve, or installed it backwards. This too was demonstrated in the video.
Thanks so much! I bought this and found the wordless instructions frustrating and unclear. We got a new (replacement) driveway, with the surprise "benefit" of an indoor pool in our garage with even slight rainfall. Using a shop vac was killing us. Appreciate understanding how the pump works in auto mode. 4:18
You're welcome. I'd call that driveway company back and ask them if they'd like to go swimming. I'm sure they'll decline, so you can tell them you don't want to either, so they need to fix it.
TERRIFIC video! I purchased the newer model, GREEN EXPERT 1 HP but I've never used a SUMP PUMP before, and the information I got from this video gave me the basic instruction on how to use the GREEN EXPERT SUMP PUMP when it arrived. Their manual was just O.K., but I learned everything I needed to know from jaykay18's video. THANKS!
Thanks for such an in depth video!! I have owned this pump and the sensor seems to longer function. The last time I tried to use it the sensor worked for about 15 seconds and it then stop pumping. There seem to be numerous complaints on Amazon that the sensor eventually stops working. Any thoughts on how to get this thing working?
Quite frankly, I'd plug it in manual mode and call it a day. If this is installed into something like a sump, you are much better off with a float switch, which almost never fails. That way you are guaranteed at what level it turns on and what level it turns off. If you are using this to pump out a flooded basement, on the other hand, I'd stay and watch it. No basement floor is perfectly level, so when the water gets down to the floor there are going to be little pockets and puddles you're going to tote it around to anyway. I haven't taken my sensor apart to see what's inside, I'd imagine it's some sort of corrosion that is inhibiting its performance. For me, this pump serves as a backup for a backup of the pump I briefly showed in my pool, so it could be decades before I need to use it.
You've told me nothing more than "it's not working", but have provided no details on what you have or have not done, and in what fashion. Without those details, nor seeing what you have done wrong, there's absolutely no way to tell.
Do you mind if I ask a question? Just to be sure- it seems that it’s ok to keep the pump plugged in PROVIDED it’s NOT in manual mode, correct? So if I have it plugged in and either have the sensor on the ground or the sensor is plugged into one of the three ports under the manual port, it’s fine to leave the pump plugged in. But if the sensor is plugged into the top (Automatic) port, I have to be ready to unplug it because it’s no longer going to “self-shut off”. Do I have that right? Again- thank you for your video. It was incredibly helpful.
The only time you have to stand by is if it's in manual mode, because it will run continuously. You don't want to run out of water while you're not there and burn the pump out. In any automatic setting, the pump knows if it has water or not. If not, it shuts off.
Great. We’re in California, and they are forecasting some really intense storms out here over the next few days. Record-setting rainfall and major flooding. I feel like we’re prepared now that I have two pumps in place. But didn’t want to have to run in and outside, plugging and unplugging the units. I’ll leave them on automatic, as flooding will occur several times over the week. Thanks again for all your help. Much appreciated!
@@MattSingerman-jv6cr No problem, best of luck to you. I hope you don't even need them and the storm isn't severe. Like here in NY, we get snow. They were forecasting a storm, so I got my snowblower out, gassed it up and got it running to make sure it was good to go. The weather changed, we got very little snow, and it was unneeded. Chances are good I won't need it at all this season. As the saying goes, "I'd rather have and not need, than need and not have".
A cheaper alternative would be to make the packaging better. Mine arrived just fine and I have reports from many others that theirs arrived fine as well. Perhaps there's a bad box of them, or the pallet was dropped.
@@jaykay18 I have water that comes in on did of my garage. I encased this water with 2x4s and made a trench to control the water with the green pump it worked fine for a few times. This pump would be great for it low pickup. I'm not sure if I can find one with a float switch that has the low water pick up the green pump has
@@donaldjenkins7923 Yeah that's true, might be hard to do. They do sell separate float switches, they go to a plug with an outlet on the end of it. The float controls the outlet, and the pump plugs into it. Usually includes a small metal clip that attaches to the wire, you choke up on it or extend the wire to allow the float the right range of motion. If whatever you have is watertight, and there's enough room, you should be able to make it work no problem.
@@jaykay18 thanks for the info. I will figure this out even by modification of a simple condensate pump. But sure wish this green pump had a better sensor it would have worked perfect . I read a lot of reviews on this pump and that was the problem with most reviews