Sir ask lang Yung current sensor switch ba na gamit mo Jan pwede madetect Ang flow ng current like papasok or palabas ng grid. Kasi if sakali pwede mas madali nalang Siya I modify.
hi mr peter nakapulot ako ng maraming idea dito sa pt2 and solved some of my question but the setting ay medyo mataas before the gti on ,how about .lets say i load rice cooker with 300 watts while cooking tapos ng maluto it shift to standby of 40watts..yun babg set up mo still on the gti...same with ref with defroster with different wattages in compressor running and defroster..thank you for a great diy..
thnx po sir delrey, hmm sa setup po sir n ito bale my preset po kau kung ano po ung idle output po ng inverter sa low, den need po mag add 2 more transfer relays and 2 more current sensors, na mag shift naman po ulit, like 1,2,3,4 settings, if multiple loads n my ibang watage , pero po same principle lang sa pag current sense,, itry q po ulit idraw ung diagram, para sa mga relays n my ibat ibang potentiometer. and try also demo para po sakali makatulong muli
and opo kahit po mg jump sa 300 watts automtc po un output nya mg shift dna po daan sa low setting , ung sa video po my part po dun n nabangit q n pwede xa mgshift agad sa higher setting, if higer output po need ninyo sa 24v po kau if ganito setup. nag output po ng aroung 500+ watts ung gti na ito
Thank you for your great video. I have the same idea, but I use Arduino with 2 current sensors (1 for load and one for inverter output to control the duty cycle of the PWM. If the load < inverter output, PWM duty cycle will be decreased. It works well with a led strip but when I plug into the inverter, it does not work, inverter does not start up. I connect inverter negative to the mosfet drain and the battery/ solar panel negative to the source pin of mosfet. Positive is connected directly to the inverter. Do you know what wrong? Thanks!
Good day po, pwede po gmitan po ninyo ng step down po ung para sa relay if ung sa relay lang po ng POT ung tnutukoy ninyo , dnmn po need ng mataas na amp. Purpose lang po nun ay mag switch over xa sa ibang preset na ohms para sa pwm po.
@@abbytan9135 ung pot. Po 2cs need para po un sa pwm driver meron po aq inupload n diagram sa isang video po. Pero ung current sensor meron na po siya adjustan na trimmer. If ung " self powering transducer "po ang gmitin po ninyo mas maganda po gmitin unlike nung nagamit q sa video, and mas simple po i trim, i match nyo nalang po ung voltage source na ggmitin and ung rating ng Specs po ng current transducer.
Salamat po, may nabili po ako nung self powering current sensor switch pero hnd ko po alam wiring diagram lalu na kung dalawang current sensor switch gagamitin. .
@@charleszionquider1024 thnx bosing sa feedback, yup pwede din un Sir sinabi u, sa walag battery storage, nagbabago nga lang output dpende sa daylight, and d nga lang ma store ung exes for late use if nag zero load , pero pag constant n load ok lang hehe ung sa setup q nmn sir adjustable ung kada load n like dpende sa ipreset if multiple relay and pwede din mag inverter max peak output khit small solar lang gmit pag 24v and mag off xa pag walang load and store energy for later use hehe