check if the actual input setting corresponds to the switch setting, if yes, interchange the wires from the sliding switch, remove (desolder) the parallel wire lines interchange it to bridge connection wires. the supply of 9500 is 105v-52v-0v-52v-105v, same circuit driver and output transistors.
Nag-iilaw talaga bridge led indicator sa harap niyan Sir Ox kahit nasa parallel yong selector sa likod, yan gamit namin for bass, malakas din yan bumayo.
Ganyan po talaga pag tosunra sir pag nag parallel ka umiilaw na yung indicator sa bridge ... ganyan po talaga design nila kasi lahat ng binili ko na tosunra walang pinagkaiba
Wow super wow yan ampli and other gadget mahilig ako sa ampli pero di ko na inabot yan malupet na yan.your new subscriber sana madalaw mo channel ko good day enjoy your sound sarap hatawin pag new year
Done watching sir OX. Grabe lakas nian kung masound check lang ng maayos. Ang lupet ng bagong tosunra power amp. Mapapa "Wow" at "Sana all" ka nlng. Pashout out sir OX. Salamat, sana mapansin mo.
Sakin tusonra da8660 ganyan din parallel iilawa ang bridge naka mono kc yan dapat isang input lng gamitin mo pero d sya tulad sa ibang power amp na channel A lng gamitin mong volume tutunog na ang channel B tusonra need mopa pihitin kabilaan channel pag naka parallel or mono.
Normal lang yan na iilaw pag naka parallel same yan sa bridge..advice ko lang pag switch mode ka sa likod dapat patayin mo muna ang amp bago ka mag stereo, parallel, bridge..for safety lang sa amp
try to select the switch to bridge mode, if the bridge led will not turn on, interchange the wires in the sliding switch, the parallel wires transfer it to bridge connection terminals. the supply of 9500 is 105v-52v-0v-52v-105v, same circuit driver and output transistors.
Sir sa loob ba i interchange ang wire ng selector. Kasi ganon ang nangyari sa p9500s ko. Selet kl bridge mode ang hina at nailaw qng bridge, select ko ang parallel nailaw ang bridge at medyo malalas, select ko ang stereo malakas pa sa bridge at mababa pa xa doon sa parallel
@@severinomacahiligjr.526 1) if the switch is selected to bridge mode, only one speaker connection and is connected in between the stereo output speaker terminals, check if this was correct, 2) selecting to parallel the led will not turn on 3) selecting to stereo the led also will not turn on. check the input signals if they are balance and check the sensitivity input variation and also the speaker connections.....
Pag maitim ang transformer nya for sure di nanaman pure copper yan sir di parin nagbabago ang tosunra na copper coated ang winding..anyway padami ng padami mga gamit mo sir ready for big event
naol nag review nadin cyang Tosunra. Kala ko di cya papatol sa mga chekwa amps. kasi hindi pure copper gamit sa psu transformer 😂 Pero malakas yan paps kahit ganyan yan.
Dapat fix mo n yang mga konektor mo meg bka maputol p mga pin ng pyesa mo para d k n tanggal kabit sakn nka fix n ung sa mixer ko n lng kakabit pag my event ako
