Thanks for the vid. Just changed an H4 headlight bulb on third attempt. As usual once you have done one, the next time will be easy. The main problem is removing the black socket from the rear of the light bulb before you remove the rubber gasket. The manual implies you should squeeze and pull backwards. I was assuming there were some tabs which need depressing to get it to release. There are not. It really is just a case of pulling it back firmly and the bulbs tabs just slot in/out. I found mine were really solid - three people all tried in vain. I had a closer look at the socket on line and once I realised there were no tabs to depress and no wiring to damage on the sides I used a plumbers wrench to grab the socket rear - couple of wiggles and back-pull and off it popped. Easy peasey - Why has no one mentioned this before? Please tell everyone - shout it from the mountains - no copyright. Yes I am enjoying my cup of tea and biscuit victory moment.
Thhankyou forthe ideal demonstration, with fotos, in other clips the demonstrater works with hands in the motor, you don‘t really see the actual process. the fotos dhow the site and the process ideally
Unfortunately there's a third bolt holding the front outer edge of the unit, behind the bumper. You can see it here: ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-0nTN6sz8R1U.html
Thank you for the high quality close up photos! I had a problem with beam not being formed correctly and thanks to you I realized my bulb dropped low when I was putting on the bracket! Corrected it and now it's as it should be 🎉
Really useful video thank you, managed to change the lights! One question, I've also changed the side light bulbs but they don't seem to be working, also checked the fuses and they seem fine. What do you think the problem could be?