Heavy Furniture Lifter 

put pipe over the handle to lengthen your handle, power of leverage

I moved a 1,400 lb lathe by myself. I used two 6 ft lengths of scaffold plank (9" x 1.5") and 4 x 3ft lengths of scaffold tube as rollers. I even manoeuvred it around a 90 degree corner using a crow bar. Took a bit of doing to get the lathe onto the planks but unlike you I didn't give up after 5 minutes. BTW, if you'd paired the corner rollers each with a length of 4 x 1 inch wood then placed one pair each side I'm sure you would have succeeded. Lever it up and place wooden blocks under it to allow the paired rollers to go underneath then do the same the other side, then when the rollers are in place jack up and remove the blocks. Reverse the procedure to get it off the rollers. Easy.

That is how you lose toe nails and toes wering open shoes around heavy lifts.

A cheat bar would help with the leverage.

That was all user error..

pls move all the 4 wheels into the corner ... make sure they are position nicely ... before you push the box ..

Dude you did not did it right, you need another person to help you to do so. Also wear some shoes. If you need to do it yourself be patient inserting each block one at the time correctly.

Hire somebody to do it before you hurt yourself.😂😂😂😂

It's useless product I buy tht too but always these wheel slip , I fix them on two boards then move one side then otherside ... But after tht too it's not as easy as shown in advertise

If you used it correctly would be easy

নিতে চাই দাম কত

You are in wrong direction. This is very easy. But you made it all wrong. put the wheel under stand

I think you should stand up and step on it using your body weight,,,,just my opinion, not an expert.

Not a good idea too sat down on this kind of job,makes you look lazy(LOL)