Listen I appreciate you taking the time to post and share your design!!!! It is unfortunate that people have negative things to say about your video!!! Keep up the good work and keep sharing!
Great design. I will give you a couple of additions to make it work better (sorry I did not take pictures of it at the ranch) when you put your feeding tubes on, instead of cutting the lip, glue a 16 degree or a 45 degree turned up and then glue on a 3x6 bell reducer. This will stop the feed and give the deer better access. Hope the discription makes sense without pictures
It does work I took your design and made two of them so far. Had two wildgame innovation spin cast feeders and just attached them to it and works awesome.
Also, we use 3" just like you, EXCEPT for the mouth pieces (where the deer actually eats), thin wall 4" pvc will slide OVER the outside of the T fitting, giving you a larger feed area.
Just a side note. After doing one like yours we decided to NEVER glue the pieces together again. Do yourself a favor and use sheetrock screws to hold the pieces together that way you can easily dis-assemble the pipe for cleanout should some other critters make a home in it (birds, bees...etc). Also, the bends in the ends are not necessary, the feed will not free flow out unless you are using round soybeans or similar.
+Troy Folley Sorry. I didn't have any editing tools for professional production. But at least when I say it take 15-20 minutes to make, you know it's the truth.
