Homemade Sheet Metal Bender I have used 2.5 feet long 50/50, 4 mm thick angle iron to make this sheet metal bender. Music Osheen & JayJen - Flying (Vlog No Copyright Music) • Osheen & JayJen - Flyi...
RODE MOJ, ŽELIM TEBI I SVIMA BOŽJI BLAGOSLOV. TRAŽIO SAM DA VIDIM KAKO NAPRAVITI JEDNOSTAVNI, ALI DOBRU NAPRAVU ZA SAVIJANJE LIMA. EVO SADA SAM VIDIO TAKVU NAPRAVU SAGRAĐENU JEDNOSTAVNO ALI JAKO DOBRO. LIJEPO JE SVE PRIKAZANO SA PUNO UMJEŠNOSTI I LJUBAVI PREMA POSLU. TO ME RADUJE . ZAHVALAN SAM ZA IDEJU. ŽELIM PUNO USPJEHA U ŽIVOTU I RADU TEBI TVOJOJ OBITELJI I SVIMA.
Thanks for posting this. I just started making this now with a few changes. You have a 2 piece hinge, I’m using a 3 piece hinge. The center pin will be removable so I can separate the 2 angle iron pieces. The top clamp part that is held down with bolts I’ll be milling the leading edge so it’s flush with the metal that’s being bent so I can get a sharp angle at the bend, not a rounded one.
So your one can make hotdog and hamburger holders, perfect for barbeques, hotdog stands and burger vans if you make them from stainless steel. Great stuff, thankyou for sharing.
Weld a washer or metal plate on top clamp bar under where screw down is. Makes for better clampdown. Have made many benders like this in past..Plus weld some spinner handles so dont need an allen key to tighten it up