Honda CFR250X Carburetor removal | DIY Repair | FULL Disassemble and Reassemble 

dont need to do that mate just take out bottom bolts and losen the top it will lift up then tighten the top ones the half frame will stay in place ,when ya done losen the screws drop it back down put bottom bolts in ..ya dont need to take full frame off just take bottom nuts out and losen top ones and lift it then tighten to hold in place while you work,the frame will hold in place lifted up

Good lord. Step 1.) disassemble 75% of bike. Step 2.) remove carburetor.

Bikes sat too long in my box trailer! Bad gas and wont start!! What a pain to remove these carbs!!! Thank you for taking the time to show people the proper way to remove and replace these carbs!!

Just got done pulling mine man what was Hondas engineers thinking.

This is insanity

Engineering…”but you’ll have to remove everything to get to the carb…No they’ll have to” Problem solved.

I am trying to do this on my bike now and I've gotten almost to the part where i can remove the carb. I cannot figure out how to remove the throttle linkage from the carb though, its a circle with cables on the top and bottom of it which rotates when the throttle is twisted. Probably the same as the one in the video. How do I take these off?

Hugley helpful thank you for all the detail. It was my first time doing the carb and I wouldn't have gotten too far without this video.

а я думал у меня трудно снять)))

Looks like a nice little project I got into

Hello there, question for you since you are well versed in Honda CRF’s. I have a 04 that idles fine and sitting it will throttle up fine however when I kick it in gear and try to take off it will bog down really bad and almost shut off. I checked the accelerator diaphragm which seems ok, any suggestions on what to check next? Thanks 🙏, great videos btw they are a huge help.

Great video just bought an 06 250x qnd it's dumping gas as soon as the gas is turned on

Thank you for the vid! Hope I can get the air boot on tomorrow!

Hi, do you know what size are the vent hoses that come out of the carb? Is it 3mm or 4mm? Thanks,

Helped a lot ! Seemed to easy to get out with the video! Thanks

Great video. thanks for the help.

Quality video. Just wish it wasn’t sped up so much because some parts were hard to see as it is.

Thank you! I just bought a Honda 2001 cr250r and it had bad gas so I cleaned out the tank and removed the plastic too and, it was a bitch to remove the carb. Thanks man

This is so helpful. It deserves way more view and likes. Thanks for doing this. I subscribed just to support your channel whatever else you cover.

I’m having trouble putting the throttle cables back on