Got so much potential as a RU-vidr but think you need to up your game a little bit no before and after sound no good cinematics I know you said about flat tyre and battery but there easily sorted sure you could have got a pump before filming and sure you could of got a bump of your mates car or even got your mate to drive you for a battery and documented the drive adds a bit more character to the content too just some friendly advice and criticism mate or even could have inserted some clips after you filmed once sorted
Tegiwa adaptor plate, needed for the RBC to mate up to the OEM throttle body. Idle Air Assist Valve can be blanked, it’s not needed. You’ll need to blank the port on the silicone intake hose. Lots of kits on eBay for that. Idle being a bit up and down will most likely be the IACV, go out and bounce it off the limiter a bit, clears it out, or you could remove it and clean it but that’s more of a job. If not, the Acuity TPS is the one to use but you’ll need it calibrated via KManager. Tegiwa intake will vibrate, it fits like shit. Can put some foam tape underneath it or on the scuttle to stop it. The breather hose from the valve cover to the intake is wrong way round btw.
The idle air control valve is at the bottom of the throttle body which affects idle. Take it off and clean it. You were pointing at the tps sensor. Which is worth changing for an Acuity one.
Thanks for the shout out man! That TPS has been changed before. The OEM Honda ones don't have removable screws, you have to cut into it to get a screwdriver on it. The Acuity one is great though!
In regards to opening bonnet rather than putting your hand right in and pushing lever to the side put you hand under the very front of lever and lift up that should tilt the latch to the right to release the bonnet Might be wrong just give it a try.
the long pipe that goes into the breather side of the rocker cover is wrongly installed. Thought it will still do the same job but if you got OCD it's annoying
Where about you from Mon? Motor is sick, found you through the Mégane rear seat delete vid....my bro just grabbed a meg and is doing the same. Subbed 👍👍👍
@@JustbeingHayden you going santapod on the 1st of aprill rwyb I'm recording some serious footage for my channel I'm bringing my s3 8p 310 bhp and my fn2
That looks like a Tegiwa throttle body adaptor for an RBC manifold, rather than a Tegiwa throttle body. Cool intake though! See you have a nice wrapped exhaust manifold on there too. Is the car remapped already for these mods?
