No video :(

Honda Pioneer 1000-5 lift kit

Подписаться 944

Просмотров 18 тыс.

50% 1

After adding the 30 inch tires I decided to lift the Pioneer. I thought about adding a bracket lift but finally decided on adding spacers. You will need two pieces of 2” schedule 40 and two pieces of 3” schedule 40 steel pipe cut to 3/4” or whatever you decide. It firms the ride a bit but I actually think it rides better now.

Опубликовано:

20 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 32

@grounds4life 4 года назад

Good info.... Thanks!

@davidrutledge9180 4 года назад

Hey are the measurements id or od

@adamaustin3373 4 года назад

can you do a video review on your super ATV windshield...and also, of you had done the 1" up front like mentioned at start...there would have been a really big rake from front to back right correct? would you recommend doing 1" on rear and 3/4" on front?

@russ9897 4 года назад

Adam Austin, I sure will do a review video for you. As far as the lift, let me get some measurements and get back to you. Thanks for watching.

@mauromartinez9236 Год назад

Do I need wheel spacers if I am installing the shock spacer?

@russ9897 Год назад

I would add spacers anytime you lift a rig. If you go up you should go out.

@marvsellers 3 года назад

What size spacers ya use up front? Also what size tires an rims?

@russ9897 3 года назад

Sorry for the late reply. I’m running 1” spacers in the front, the wheels are 14x7 with a 6+1 offset and 30x10x14 tires.

@byronanglin2316 2 года назад

I was wondering does it still ride the same or is it a little bit rougher

@russ9897 2 года назад

It firms it up a bit but still rides good.

@jessewoody5772 2 года назад

It will be stiffer because lifting in this manner is equivalent to a good six clicks or so on an adj. preload shock. Its good uz you stay within the intended travel of the cv joint, but you give up some droop and suppleness

@jonathonraney5832 3 года назад

So those 3/4” spacers yielded you a couple inches of lift?

@russ9897 3 года назад

Jonathon Raney, roughly 1 3/4” of lift.

@jbuchanan9638 4 года назад

Did you adjust your alignment afterwards? Or was there really no need to?

@russ9897 4 года назад

No alignment needed after the lift but I did have to do some alignment work after the a-arms. I’d say the lift affected the camber more than anything.

@jbuchanan9638 4 года назад

Russ989 appreciate it man. Really enjoy your videos. I’ve got a pioneer 1000-5 and I ordered a 2” lift .. can u clear 30s with just 2” lift or u think I for sure need aarms too?

@russ9897 4 года назад

jbuchanan96, you will need the front A-arms without a doubt. They are forward arched to help with bigger tires. I ran my 30 with a-arms and no lift but then put the spacer lift on to help in off camber spots when the suspension loads up.