How I dyno tuned this 2016 GSXR 1000 in 2023!

Подписаться 7 тыс.

Просмотров 5 тыс.

50% 1

We install a full M4 Street Slayer Carbon exhaust on this beautiful 2016 GSXR 1000 and go in depth with an ECU flash and dyno tune. Come with me as I walk you through and explain EXACTLY what we're doing to get the bike to sound great and make respectable power!
Let me know what you think and what you would like to see in future videos! Like, comment, and subscribe! It is greatly appreciated!
Thanks
-Eric

Опубликовано:

6 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 33

@TheMoghrabimahmoud Год назад

U r a walking talking school More content like this pllzzz

@provenpowercycles Год назад

I appreciate the compliment! 🙌 we will keep producing videos to help you guys out! 🤙

@ready_to_run_motorsports_ Год назад

Love the video!! I was just curious the style filter you guys used? I downloaded the "ripped" and "arm pump" filter and neither made my arms look that swollen...

@provenpowercycles Год назад

😅😅 you gotta get the wode lense camera. Adds about 3" to your arms, chest, and gut 😂

@jmsti Год назад

Great video. I love it. Do you think need tune again for E85 fuel?

@provenpowercycles Год назад

If switching fuels, then yes, I highly recommend getting a tune for E85. Especially when going to an alcohol based fuel vs a gasoline based fuel! 👍👍

@Dr-AliHussain Год назад

Want the yoshimara slip for my cbr 😭

@provenpowercycles Год назад

I would recommend the full system if you can. They breath a lot better than stock system 🤙

@chitoloveone7565 10 месяцев назад

What’s the top speed?

@mouhamedh2029 Год назад

Hay bro I'm just curious did you switch it to a mode when you dynod it or did you just leave it with modes off

@provenpowercycles Год назад

We don't switch the modes when dynoing typically. Whenever you restart the bike, it should start in A mode even though it doesn't pop up on the dash 🤙

@uberdriver5711 Год назад

What do you look at on Woolich when correcting the amount of fuel needed. As in points or percentage you need to correct the afr per cell.

@MrThecrx Год назад

If you want to adjust by a percentage then i would use lambda values as it makes tuning heaps easier once you get used to it . 14.7 afr = lambda1 . Lambda .90 = around 13.2 . So if you were at 1.1 lambda and were targeting lambda 1 you are 10 percent out .

@provenpowercycles Год назад

Different tuners utilize different methods on tuning. Ve tables are usually manipulated by percentage rates but again, different strokes for different folks 🤙

@tonelada1987 8 месяцев назад

Do you have a shop in fl

@provenpowercycles 8 месяцев назад

Yessir. We are located in St. Petersburg, FL. 3127 Tyrone Blvd N St Petersburg, FL 33710 727-256-0001

@tonywilliams3677 Год назад

Can you tune a Rocket 3

@matt99943 Год назад

Would a longer traditional style muffler gain mid range?

@provenpowercycles Год назад

I'm not entirely sure. I would need to compare the same bike on same day with the 2 different exhausts in order to make a fair comparison. However, I have seen on different models different power curves with a different style exhaust. I'd like to do a comparison video on the different types of exhaust sometime in future!

@matt99943 Год назад

@Proven Power Cycles M4, etc, make both under and normal vs Cs racing make the under-body like the old Taylor mades

@provenpowercycles Год назад

@Matt Bonham so I can tell you that most (not all) exhaust style like Taylor made don't make the best power because they put in an additional box or cat like setup under the bike. It creates turbulence and messes up the flow causing torque and hp loss in low to mid range areas.

@matt99943 Год назад

@Proven Power Cycles yeah CS racing has a dyno vid showing good overall HP gains, but don't show the results very well. They run a muffle where was was then large out pipe

@MUHANADHONDAA 6 месяцев назад

My gsxr also making this sound look like (vu vu vu )on 20% throttle position I think i need to change chain Is that sound is issues

@SquidOnGixxer Год назад

What would be the power output in the crank?

@SquidOnGixxer Год назад

Also how these bikes are sometimes faster than the modern bikes with so less bho

@provenpowercycles Год назад

Usually there is a 13-15% drive train loss when measuring to the tire vs the crank. And there are a ton of variables when comparing how one bike is faster than the next. Examples are the overall weight, torque, and aerodynamics.

@nicksonjeremiah9164 Год назад

Hey Quick question...what times do you think its gonna run in a quarter mile with the 173hp...by the way great content👍👍👍

@provenpowercycles Год назад

With an average rider and being that this bike is a stock wheelbase and stock height, it is probably a mid 9sec to Mid 10sec quarter mile👍 and thanks man I really appreciate the feedback!🙌

@nicksonjeremiah9164 Год назад

@@provenpowercycles ok nice