Reading comments I see this only works if blowby is caused from sitting. What’s happening while sitting that causes blow by?? My Kubota sits during winter. Is that ok? Usually 4 months or so.
I have a iseki Tl2101F E3AG1 engine with enough blow by to rattle the breather when turned up side down on the breather pipe, could this work for my engine? over 2500 hours, was in severe need of fluid and filter change when I got it, fuel filter had sludge in it.
@@tractorsmarinemechanic my youngin was mowing and jobbed a limb through the radiator of my L3010. Of course he ran it till it died. Once it cooled off I fired it up and drove it back to the house. It has a little blow by now, but sill plenty of power for a '00 model. Any ideas on how to fix the blow by?
And only by flushing the engine with diesel,you fixed the problem? Is interesting because i have the same problem with my kubota b 7000 and i will try your method.
Hi, I am about to purchase a satoh buck Mitsubishi 3 diesel cylinder engine , when you try to open the top oil cap while the engine is running , you feel the cap is sucked and when you take of and put your hand palm you feel your palm sucked ! Is that Good news or bad news ? Please tell me . The mini tractor is from 1980 and has 8000 hours .
Hello do you have any videos on yanmar tractor fuel injectors? I think that is my problem white or blue smoke can't tell some times knock runs rough not much power and sometimes it is ok I have removed injector nozzles a few times needle keeps getting stuck also check compression with cheap rig put together the gauge was leaking read about 320psi anyway I think it is fuel injector
Thank you for watching.im sorry don't have a video for a yanmar engine.your problem is the injector.just remove all injector and calibrate one by one.thank you
Just try it if your tractor didn't used for several months then blowby is coming out but when you used every other day or everyday your tractor is already blowby and need to replace piston ring or maybe also sleeve.thank you for watching
@@tractorsmarinemechanic gusto bumili. pag uwi ko nalang boss andito pa ako sa abroad. pano kaya pag transport yan sa mindanao. meron bang maghahatid doon?
How much ATF would you put in the oil? A quart? (Hinomoto E230) I have a little more blow back than normal and tried a couple oil additive. Thought giving ATF a try. Thanks!
My car is hyundai santafe 2.2 CRDI disel engine,year 2008 have blow out also same case.I want to do same thing on my engine .if I do that am worried have some problems.Can you advise me?Thanks much.
tractors&marine MECHANIC thanks reply i use car every week ,still engine had blow by .my car ODO 125000 km,however I checked oil level every 5000km then found not much loss oil level engine and engine power still ok.So is it ok or not.do we replace ring & piton?
Kpg po mlki n Ang clearance palit k ng RING STD p rin..palit kn nrin ng sleeve kpg may tama n Ang sleeve.my sleeve po Ang block nyn.kpg mag over size k ng piston ring hndi tumatagal Ang makina.sira n rin b Ang transmission mo?or Anu sira ng transmission mo?my front drive po b Ang unit mo?
@@tractorsmarinemechanic hola tengo una pregunta tengo un 1988 john deere 750 3 cylinders que no tiene mucha presión la bombe del diésel como se saca la bomba para repararla
Sir UNG tractor ko nagganyan din ako..nilagyan ko isang lettro Ng krudo at pinaandar Ng ilang menuto ska ngchange oil..pagkapandar ko ganun pa din sir may usok parin sa breather..ano Kaya gagawin ko sir...slamt
Lagi mo b ginagamit ung unit mo?Kung madalas mo gamitin ung tractor mo at may usok n Ang breather at hndi maalis Ang usok.blowby n po tlaga un at kailangan mo ng tingnan Ang piston ring at sleeve.baklas in po ng tractor mo,pero Kung malakas p nmn wag mo Muna baklasin.anu model ng tractor mo?
@@tractorsmarinemechanic ah ganun po ba sir...malakas pa nmn po sir ...mejo mausok Lalo pag nag aararo at biglang lumalim Ang kain Ng rotor...zl2202 ung unit ko sir...magkano magastos sa frontdrive nya sir kc nabili ko Wala na laman sa loob pati UNG ilalim nya na umiikot papunta sa harap...salamt sir
Lahat b walang laman pati ung drive gear nya s ilalim ng differential?malaki Ang maubos mo dyn sir.bumili k n lng ng kompleto kpg nkaipon k.pki like nmn sir ung video ko share and subscribe k po.salamat.
Hi I have the same engine and it’s a pain to start when cold, glow plugs are good and working, all filters new, diesel drained and new diesel, new 12v in line fuel pump, injectors tested and new nozzles, did numerous oil flushes in case it was sticky rings adjusted the valves and when cranking there’s lots of smoke 💨 and it’s trying its hardest to fire, any suggestions ? Is there timing on the pump or adjustment any help would be greatly appreciated thank you 🙏
@@tractorsmarinemechanic thanks so much for the speedy reply, smoke is white black it’s like unburnt fuel, I don’t think I have the plunger on my model, are you referring to the plunger with the rod ? My machine will Only start in a particular position on the throttle lever it’s very fussy
I think Your injection pump.is the problem.i have many injection pump videos you can watch and learn.is it the rack or lever hard to move,maybe one of the plunger was stuck up or delivery valve.
@@tractorsmarinemechanic thanks again, I might remove the pump and inspect its plungers, everything seems free nothing is seized or stuck, I subscribe and watch a few of your videos thank you 🙏
Wag mo lalakihan sir kc magkaprolima k hood at cover.isa pa Kung ayaw maalis init,palitan mo ung fan blade Ang ipalit mo ung sa L2202 or sa L2402 kc pareho lng Ang radiator nila iba lng fan blade,fan at cover lng Ang palitan mo.salamat at keep subscribing at paki like and those my video you've watched.salamat ulit
I have heard of this many times but never tried. Isn't there a risk that the engine can get into a runaway condition where it starts burning diesel from the sump? I suspect that could happen on a worn engine. I would watch the engine at all times and be ready to block the intake with a flat surface of some sort. Whatever you do, on't use your hand!
in that case get a rag or a piece of flat wood that can block the intake. the engine is not smokey at all. similar condition to my d750 and i bought a d850 to replace it ! will surely try this before i start undoing the engine and keep the D850 as a spare or take it back!
