How loud is a @PWNCNC spindle vs a Makita trim router. 

I think the sound being produced by the bit spinning at the same rpm traveling at the same speed through a given material would be identical regardless of what is turning it so that’s why I didn’t record it cutting Hope that makes sense

I get that but my Makita is significantly louder when cutting. It’s loud enough when not cutting! Would just be interested in the db comparison under load since I don’t know anyone who runs their machine for more than a few seconds without cutting.

So many new and exciting possibilities stay tuned!!

Thanks again sir Without you and PWNCNC providing the spindle this video wouldn’t have happened for quite a while THANK YOU AND PWNCNC AGAIN!!

Yes it will accept 1/8 1/4 1/2 bits

When the bit is cutting there is a considerable amount of unavoidable noise but still much less than with the addition of a traditional router

Thanks for watching the Allen. Keys came from Harbor freight.

I’m right there with you my planer drives me nuts

Hello Ryan I used a Makita screamer for years, so I know your pain. I am absolutely satisfied and pleases with my PWNCNC spindle. It is the 115-volt unit I was unaware of the ability to operate the variable drive manually until I received it. Using it that way is very similar to how you use the Makita except you have the added benefit of rpm control and super noise reduction. I have added a link in the description to PWNCNC to help you find them.

Sorry Paul you’re right I forgot to put the camera on the drive display But, the spindle was running at the same rpm as the makita To make sure the test was fair and accurate

Hey Billy, thanks for watching. The spindle is air cooled 115 V AC.

Thanks for watching the z slider I have is @onefinitycnc version of a heavy duty slider

X50 journeyman