How to assign a coordinate system in Civil 3D 

Excellent video, full of useful information.

Great Video, easy to follow. I went through a lot of them and none made sense. Again, thanks for making it simple.

Very helpful.

I've recently been having a problem where I will set the same coordinate system for two drawings, then make sure the units are the same, but when I turn on the aerial, the actual red circle representing the origin of the coordinate system ends up on a different x,y point. The drawing then do not line up when xref'd into each other. Any idea what might be causing that?

Thanks!

georeferenced based on sat picture? I think this is good tool only for those who are curios in general, but not for surveyors

thank you

I luv this

Is this applicable to convert a local coordinate to utm by following this step. thanks

is there a way to set a default zone? annoying having to do it every time

Any way to then convert it to another coordinate system??