How to attach the Landing Gear of the 2350mm Black Horse Gilmore Red Lion - Wedell-Williams 44

Подписаться 820

Просмотров 1,9 тыс.

50% 1

I'll show you how to attach the landing gear and tail wheel in this episode. Also, a special bonus, I ordered the extra set of wheel pants from @MotionRC and there was a pleasant surprise of an extra spare piece I was not expecting. Check out the end of the video to see what it was!
About the real NR61Y:
"The gear was attached at the wing root area, projecting outward at an angle of 10 degrees to prevent them from buckling inward. The gear struts were attached to the wheel axle on the inside of the wheel so that the wheels and covering were parallel to the vertical plane or Z-axis. These factors allowed for an enhanced performance in crosswind landings. Goodrich low-pressure tired provided shock absorption." - page 29 - Wedell-Williams Air Service
About NR536V (#92 Miss New Orleans)
No. 92 would also be a Model 44 with outward appearance very similar to NR-278V. However, the landing gear legs extended from the wings in almost a straight line while No. 44 angled out a bit.
The Wedell-Williams Air Service (Book) - amzn.to/3mubVGi
1939 Cleveland National Air Races (Clip 02) - • 1939 Cleveland Nationa...
Crawford Auto-Aviation Museum at the Cleveland History Center - bit.ly/32ZknnR
#2x3/8" Button Head Socket Drive Sheet Metal Screws - bit.ly/3xndk6i
HobbySquawk Forum Thread - bit.ly/39gQNxW
50cc Gilmore Red Lion ARF by @Black Horse Model (@Motion RC) - bit.ly/2Wqw4Ei
2350mm Gilmore Scale Detail Parts from Black Horse - BHM1003-117 - bit.ly/3xk7hjd
FlyingGiants Forum Thread - bit.ly/2PeXlpI
RCGroups Forum Thread - bit.ly/3t2QK0h
RC Universe Thread - bit.ly/3dF8ERI
Setup:
Dualsky GA6000.9 160kv Electric Motor - bit.ly/3suhkiy
HobbyWing FlyFun 160HV ESC - bit.ly/2PbrPJl
HHitecMultiplexUSAD 645MW Servos (Ailerons) - bit.ly/3dd2eaS
Hitec D951TW Servos (Elevator Halves) - bit.ly/31ne1hh
Hitec 9381 BRUSHLESS Servo (Rudder) - bit.ly/31nCxip
Jeti DS-14 Radio - bit.ly/3cpMBO8
Music - Jazzdingo - Jugoe (www.jugoe.com)

Опубликовано:

15 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 8

@octane2099 2 года назад

This is gold I'm thinking of buying this plane never built one before but if I do end up getting one this will help.

@djmoosecom 2 года назад

Thanks for the comment and watching!

@curtusua Год назад

Hello… just purchased the model and will be delivered tomorrow. I am curious how you attached the wheel pants to the struts. Did you use screws like the other parts? Any chance to see a photo? Also, what size prop did you use? Thank you!

@djmoosecom 11 месяцев назад

I used the same small screws that I used for the "shoulders" near the fuse. I didn't try something fancier as I have a few pairs of replacement pants and I wanted to be able to change them out without having to deal with glue. I'll post a closeup pic later. Thanks for asking! Enjoy the plane! Let me know how it goes!

@curtusua 11 месяцев назад

@@djmoosecom Thanks for the reply. I purchased the same motor as you and was curious what your final battery configuration was? Did you have to add weight to the nose? Als, what size prop did you end up using? I was thinking a 22 X 10 or 12, Xoar. Thanks!