How to Build a Campervan VW T6 Series 6 Episode 5 

Where can we get the corner profile from?

@@davidball8634 Morlands should have something like what's in the video. Many thanks for watching

Many thanks for watching

Thank you John , it means alot mate.

Thanks Mark, see you soon.

Yes it does take longer but they look really good. We don't normally do it this way but the customer asked for it like this and they look great. Many thanks for watching

Thanks buddy, might try making a career out of it one day haha

Sometimes you can but I did buy in an extra sheet of furniture board for the doors and I did use some of it. Many thanks for watching

Hi Wayne, do you mean the top locker stays? If so not too sure on the size but dont think they make a smaller size than them anyway. If you need some just email the office and they will be able to send you some out. The openings of the doors and the doors themselves are cut carefully by hand with a jigsaw, then i use a slotter for the t trim to be inserted. They do have a wurth account but might be worth asking them if your selling as we deals with alot of different companies. Hope all this helps and many thanks for watching.

No I jigsawed everything by hand on this one👍

A fine cut metal blade normally depends on the furniture board. Many thanks for watching 👍

I will ask the bosses

Hi Will, a company called hafele but you can purchase then from B+Q. Many thanks for watching and please don't forget to Subscribe

It was a single lip t trim or t section it's sometimes called. You could use double lipped it wouldn't make any difference really. Should be able to find some on ebay. Hope this helps and many thanks for watching 👍

@@dantheman321 thank you for answering. Do you cut a groove in the edge for the "T" to fit in?

@@tysonDK yes be careful what sized slotter you buy as too small will split the wood and too big the t trim will just fall out 👍

@@dantheman321 i will. Thank you again Great channel

On this van the profile was plastic but it is usually aluminium. Yes we reused the wood as much as possible sometimes we had to cut a fresh piece but the doors needed making smaller as you say to allow for the t trim. Many thanks for watching

@@dantheman321 how do u make smaller ,jigsaw? If using router to cut out doors what size bit that gives room 4 the t trim

Not quite following you on that one but if you mean is the width of the jigsaw blade wide enough to allow the frame and the door to have the knock on edging the no you need to take more off the door to allow for that. Hope this helps Many thanks for watching

@@dantheman321 well guessed and yes thank you for your reply, that's what I meant. Would a router work to make the gap wide first time one cut?

@@citroenrelaycampervanselfc9552 it all depends on what knock edging your using and the thickness of it. I think reimo do one which has a specific sized router but for the job but in this case I cut the hole out applied the knock on then drew around the offcut to make the door size. It was abit long winded but it worked👍

I got mine from www.morlanduk.com

@@kenny2kuk thanks Kenny ✌🏼

@@kenny2kuk had a look on their website but I can only see t trim or iron on edging, not the silver 90° joints that run horizontal at the bottom of the wall cabinet fascias???

Try Magnum Motorhomes in Grimsby. Got mine there. 🚐👍

shop.morlanduk.com/vehicle-conversions/accessories they do a plain driftwood walnut

Its loft insulation, we have been using it for 25 years and never had a problem. Many thanks for watching

Thanks