How To Build a Shed or Deck Foundation 

Great video, I've got a shed to erect and this is much easier than laying a concrete base

Great job, great info. We are starting our shed porch this week.

I believe here in New Zealand our regs would require the outside frame to be sitting on bearers on the posts for stronger support rather than relying on screws or even bolts which could shear. Also a double for each outside 6x2. I know it’s only a small shed but one never knows what could happen with any future use, so better to over strengthen. Also the span of the joists seem rather long without anything under the middle to help support and stop any sag.

Thank you! Why not to use pavers & put the roof attached to the existing shed over it? What disadvantages and advantages does this solution has? If you make addition to the existing shed that’s the total square footage includes the existing shed and the new addition? If so it will exceed 200 ft.² and in this case you will need to ask for permit from the local government.?

Looking Good !!!!! I added on one side of my shed 2 years ago , and now its time to do the other side , the 1st side is a gravel floor , this one will need to be wood , Great Video .

great job . . what I plan to do with my shed floor . .I will put down 4" layer of 3/4" crushed stone on area that floor will cover . . if you do it this way you will not have a family if skunks living under your deck . . .all skunks and raccoon do not like walking on sharp stone it hurts their feet. No animals will live under your shed. . . get a box of moth balls and spread moth balls on the crush stone . . . no skunks or other animals like moth balls . . . . trust me . . .its logical advice and cheap to keep pests out . .mice hate it as well... skunks will spray you . .raccoons will bite you and mice poo is not healthy . . .. best of luck . . . Tony

I didn’t see where you checked square ? Can you please direct me to that timeline on your video? Thanks 🙏

2 x 6 no good for floors it’s fine for ceilings your 2 x 6 should be 3 inches short of 8 feet to account for your ledgers your outside beam should be doubled up to carry the load of the joist that are not supported by the posts the post should be underneath your beams I take it you live in Florida so I would assume there are some hurricane codesYou’re fast and her choice is awesome you could refine your technique make sure you know the codes in your area if it’s carrying live load you don’t want to buy six it’ll be sagging in a couple years Good On ya for taking on the challenge All outside edges should be doubled especially the spans to support the walls above one floor Joyce caring a wall is not very strong

Nice job!

I would always stick a coach bolt through the 4x2 and post, it's doesn't take long and then you know it's very strong.

I am planning on doing this same project to my 12x16 shed. It's my wood shop and it's too crowded in there. But, I'm gonna open it up to the lean-to part and knock out the wall a little bit. Like putting an addition to a house lo. Great vid buddy.

Great job!

What about noggins (timber cuts ) for strength ? AND to deter any bowing of timber or bounce ?

You know those hangers have 2 tabs that you can hammer in before needing to screw them in?

Did you ever think about putting some angle iron on the ground posts underneath the 2x6's? I don't like the idea of simply using deck screws to support them.

Aweee thank you I was looking for ideas and needed a small deck I am definitely looking forward to making this...perfect!!! For my she deck 😂...

Great video by the way So would you use 2x8s for a pool deck. The plastic 10x12 kind pools

Very well explained & job well done.Also like the fact you got the dog as your sidekick.👍👍

Awesome

Hi i assume there are no weeds under the deck because there is no sunlight. I am debating if we should use weed blocker under our deck or not.

Thank you 👍👍👍 ..Jaxx is quite an assistant too.. lol

You must be an experienced builder. Pouring cement like that and know how much water to add by eye takes knowledge of the proceeded. Great video.

How long did your concrete take to cure for you to put the plywood on.

Sorry if you mentioned it but were those deck screws or construction screws? I thought those joist brackets were designed for nails as they're apparently stronger then screws but are the proper exterior screws ok?

Would you recommend going with a 2x8 for one of those fill up pools. Depending on the sis of the pool

Great frame, you left out the weed barrior

Put your weight on top of the 4x4 posts for sheds and decks. Bolts will eventually fail, so lag bolts on the sides are insufficient and can be a huge risk when a structure is suspended.

How did the plywood subfloor work out? You said it was 8’ from the inside to inside, which means you come up 3 inches short on a 4x8 sheet. Anyway, I’m not knocking you. Looks great.

How much did this build cost you because we plan on doing this to the shed up at our cabin to keep a atv or 2 in?

I'm considering building a deck with very similar dimensions, but with posts around the edge (4 on each side) , how's this one holding up? Wondering if I can get away without putting posts in the middle also and just doing a line of noggins.

Great video. Thank you.

Hi. I’m going to build the same foundation for the 9.1x6.3x6.3 galvanized steel shed for my back yard. What size of plywood, screws and join should I use. Please advise. Thank you.

What kind of wood is that your using?

You can use spray foam gap sealer instead of concrete to set your posts

You didn't mix the quikrete? Are you kidding me? How does that even work? There will voids of dry stuff, FFS. Man, I don't get this.

Good job my friend!! I just subscribed to your channel.., very detailed and thought out instructions. Thank you very much for sharing . I will attempt this technique asap🤙🌟🌟🌟🌟🌟

How did you square the first joist?

Thank you. I do have a question, can you do this exact plan for an elevated porch with flat top? For example the ground would be a concrete slab, then 4 post 6x6x8 will be used (dug 1 1/2 - 2') and then follow your video and add my plywood, water proof and shingles? Thank you.

You want more stability maybe you got to try to put the post in the center of the hole instead of off to the side of the hose

How long are the 6x6 post?

Thank you for the video but can’t see posts being treated with Bitumen and Damp Proof Membrane? How long is that post going last before it rots under a shed or a tiny house? Regards

Simple deck foundation, I will do the same foundation but mine will be a floating deck using concrete deck block, no digging.

That’s just simple and awesome

how deep did u sink the posts again??

Excellent very informative

how much was the total finish?

Everything was good but I think went you do a great job do it the right way those escrews are suck but like I said you did good job

Good video. Gets the job done

Hi friend, i need your help, in one video, i see a VIN number location of Mustang, i need to know where is the VIN number in a Ford Gran Torino from 1974, is possible your help??, many many thanks.

8x8 at lumber store

Thanks dude

wonder if legal in florida (hurricaines) great helper.

Hi jack . You so cute

great

Adding concrete to the posts will rot them quicker.

How long and deep are the 6x6

Perfect

if you wanted a longer decking, would you essentially make 2 of these, or just get longer timbers?

You must not have to worry about inspectors. I wished I lived in the country. Thanks for the video.

gonna get that wagon