How to change fork seals on a crf70 

The whole reason i watched the video was for that missing moment. SMH.

Curious as to how you got the old seal out? Having difficulty getting mine out.

Got it, just needed a beefier screw driver.

Some times you can heat the outside of the fork with a heat gun or a propane torch

Yes, very similar depending on the year of your bike

Thanks for the input, though I only did these videos with my son’s for fun, I am a more hands on guy than a broadcaster...lol thanks

No problem, just having fun working on bikes with my son, glad u enjoyed it, ty

Thanks it was fun

No problem, did this with my son to have fun

U could also use a large flat tire iron

I had someone else who asked to, I think I had responded in an earlier message. There are a few types of tools u could use, a large flat screwdriver or a tire iron. Once the upper leg is removed from the lower tube, u just pry it up by using the top of the lower tube. . Thanks for your question

No, I was born with cerebral palsy, but have been riding for 40yrs, mx, road bike, drag Harley, plan on racing at unadilla mx rewind vintage race next year

Franklin Cycles Gotcha! I look forward to more videos, and good luck at Unadilla next year

Thanks

I get my parts from my Canadian bike suppliers , they only sell to bike shops

Xr70 an crf70 are the same bike

I used a big flat screwdriver, you just need to be careful not to scratch the inside of the fork. You can also use a tire iron, they work well too

I think I mentioned it in the comments , but if u didn’t see it I will tell you, you use either a a tire iron or a fat screwdriver to pry the out, ty

Seb Roy I wanted it to leak from the forks into the engine so I would have to change the motor oil... lol