Thank you very much , I used angle grinder to remove the chuck but I cut the round bar hitting it with hammer is a right think to do.hitting with hammer is a must and effective
this is the correct way to remove a chuck take the drill bit out look down inside chuck you see a screw turn it clockwise to removeit the turn chuck counter clock wise to remove it do not use a hammer
This kind of machine should not be used rough and tough and rather to be repaired or change of parts carefully as far as possible delicately. The inner parts may be damaged.
Ma non è un po troppo distruttivo cosi a martellate ?e poi é dicuro che non si deforma l'indotto ,ci credo poco cosi...vi è un'altro modo quello di svitarlo delicatamente.
This is the most ridiculous clown silliness I have ever seen. If you are a young man trying to learn how to work on stuff, please don't watch these afganistan/india clown shows.
To change a drill chuck , usually you turn it anticlockwise towards you, then you put its key in the chuck and tap it a bit hard with a mallet. That should loosen it.
All the drill chucks i ever replaced had a screw holding it on and then threads, but what do I know get a hammer and beat the hell out of it 🤔 shows you how dumb i am
Some electric- drills use the system of putting the key in the chuck opening the jaws fully and tapping a bit hard with a mallet on the key to un-loosen the chuck. There are other ways of removing the chuck.
That's why are this country at such a low level... Due to mentionality of the population. Need to change a drill chuck? Normal people from normal countries use the opposite procedure to assembly in a factory. This man uses the hammer. Hit by hit up to destruction of everything - chuck, gearbox, bearings. It is so easy. Open chuck, insert hex key, hold a inner axis by this hex key and unscrew the chuck.
Creo que al señor que está cambiando el mandril, lo están necesitando para sacarle un mugre del ojo a un paciente Se que lo va a lograr, lo que me aterra es cómo lo haría.
If You cannot talk in a video please don’t make one. People don’t want to be fixated on the screen for they might miss something and trying to figure out what you’re doing. Well we’re trying to figure it out. And we might wanna look away from the screen at what we’re working on once in a while. Please don’t make videos if you can’t talk.
The best thing about the helpful video, is the utterly rubbishy music. Well, I guess the laughter from watching a clown abuse a drill - with 2 different hammers ffs - was a small benefit. 😏
I only replaced one on a portable drill and it had an Allen head cap screw down the inside bottom of the chuck. I had to loosen that first, then unscrewed the chuck. It pays to read the instructions that come with a new one. I also replaced a drill press chuck, but that was Morse taper.
Yo he cambiado varios mandriles de taladro, con un solo golpe aplicado correctamente sin maltratar el taladro y sin destruir el que vas a cambiar, para mi gusto y humilde opinión esta que presentan es una mala idea