Тёмный

How to change the handle on a BMW F01 or F02 

simpleinseattle
Подписаться 113
Просмотров 45 тыс.
50% 1

I show how to place a new handle on my BMW F01 since the old comfort access handle had severed wires.

Опубликовано:

 

11 сен 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 25   
@joellachapel3335
@joellachapel3335 3 года назад
Thanks for getting straight to the point 🙏🏻 helped me out a ton
@rodym3488
@rodym3488 4 года назад
thank you, i was ready to take the door panel off, thats how everyone else was doing it, you just saved me some hassle, good work brother
@TurboDodgeXVI
@TurboDodgeXVI 4 года назад
Thanks for the video!
@abumusaryan4697
@abumusaryan4697 Год назад
Thankyou ❤
@jaywebster3616
@jaywebster3616 4 года назад
Thank you for this (so much easier than the E90). One question, when removing the door handle, does the lock remain attached to the internals (meaning I won't have to move the lock as it were to the new handle). Thanks again.
@gilgonzalez5902
@gilgonzalez5902 Год назад
Correct.
@AlexSutu
@AlexSutu 5 лет назад
Comfort access is not working on the passenger door for me and also locking and unlocking that door doesn't work from the remote. The guys from the service say they see errors in the handle which make sense since the comfort access doesn't work, but could this problem be causing the lock/unlock not to work from the remote as well? What do you think? Also I get battery discharging while stationary warning every morning.
@simpleinseattle
@simpleinseattle 5 лет назад
The not unlocking from remote is interesting. You could disconnect the handle altogether. I have seen comments that the actuator can go which will cause your symptoms. You can always disconnect the comfort access handle wiring to see. The opening mechanism via remote and the comfort access are two separate systems. On a side note, your battery sounds shot. You may want to get it replaced. Low battery itself can cause a lot of weird issues.
@JLaw1
@JLaw1 3 года назад
i'm so confused. i'm having a hard time tightening the handle back. the handle goes in , but it seems as if the screw wont move? it's frozen or something? is there a lock or something i'm forgetting? taking the handles out was as simple as loosening the T15 screw, pulling the handle out, and unplugging connectors.
@simpleinseattle
@simpleinseattle 3 года назад
If you take the handle out and look inside the area where the tab is that is closest to the screw, there is a slot for the plastic tab. I suspect you don't have it properly slotted and therefore can't tighten the screw. I no longer have this vehicle.
@JLaw1
@JLaw1 3 года назад
@@simpleinseattle thank u, got it , turned out my sh*t tool wasn't able to fit in properly in the slot. stopped at Harbor Freight and got the proper tool for 7.99. peace and blessings from Chicago brotherman :). thanks again
@akush3551
@akush3551 4 года назад
Thanks. I have banana fingers, so manipulating the torx driver isn't that easy for me. Plus, I don't know what size. I used a 5,6,8,10, and 20 but none of those seemed to work (although it could be due to my aforementioned banana fingers).
@zafer7368
@zafer7368 3 года назад
You probably got it sorted by now but if not, it's a t15 torx screw
@davidakb
@davidakb 5 лет назад
Hei did you have to code the handle again after the replacement?
@simpleinseattle
@simpleinseattle 5 лет назад
No coding required
@pelonzavala9169
@pelonzavala9169 2 года назад
@@simpleinseattle did you replaced it because it didn't rear the finger for lock and unlock
@simpleinseattle
@simpleinseattle 2 года назад
@@pelonzavala9169 it didn't work for lock or unlock. It wasn't the actuator solenoid but the touch sensor. It also can blow a 5a fuse if the handle shorts that can affect multiple systems or drain battery.
@pelonzavala9169
@pelonzavala9169 2 года назад
@@simpleinseattle thank you my fuse is good so I'm guessing is the touch sensor at the handle
@twistedcells
@twistedcells 5 лет назад
Did the faulty handle cause the fuse blow?
@simpleinseattle
@simpleinseattle 5 лет назад
No. The wires had been cut. I have heard of it draining thr battery though.
@simpleinseattle
@simpleinseattle 4 года назад
Yes. It will cause the #2 fuse to pop and all hell breaks loose!
@silverbackog9698
@silverbackog9698 2 года назад
@@simpleinseattle same thing going on with mine..got to replacement front and back left side..hope it works
@AdikTurbo2
@AdikTurbo2 3 года назад
Txh!
@vanzavanzu6151
@vanzavanzu6151 5 лет назад
Dear simpleinseattle, could you please review our products in your channel? I visited your channel on RU-vid just now. It is so wonderful! You are very professional. I am wondering if you can review our products in one of your video. We sell BMW key fob cover on Amazon and the products are in high quality. If you agree, please let me know and we will ship it to you for free! Waiting for your news soon. Thank you. Best regard from Mandy
@simpleinseattle
@simpleinseattle 5 лет назад
Sure. I dont mind. Send them my way and I will give them unbiased reviews.
Далее
iPhone 16 для НИЩЕБРОДОВ!
00:51
Просмотров 1,3 млн
Growing fruit art
00:33
Просмотров 2,9 млн
УДОЧКА ЗА 1$ VS 10$ VS 100$!
22:41
Просмотров 280 тыс.
2017 BMW 5 series door trim removel
3:59
Просмотров 71 тыс.
Honda CBR 954RR Fireblade 02 idling sound
3:32
Просмотров 9 тыс.
iPhone 16 для НИЩЕБРОДОВ!
00:51
Просмотров 1,3 млн