I have the 2kw gasoline heater with this controller. My manual tells me error codes according to led flashes. They do not seem to apply. I have code 10 and code 20. Where can I find a list of error codes?
The faults will be displayed as flashes. Count the flashes to determine the code. Number of Flashes Cause of Problem 1 Failure of second start 2 Termination of the third time of combustion 3 Voltage power out of specified range 4 Glow plug temperature increases slowly 5 Air heaters will not flash 5 times 6 Temperature sensor: Broken circuit or short-circuit 7 Fuel pump: Broken circuit or short-circuit 8 Fan motor: Broken circuit, short-circuit or clogged 9 Glow pin: Broken circuit or short-circuit 10 Overheated 11 Overheat sensor: Broken circuit or short-circuit 12 Control switch: Broken circuit or short-circuit Timers 1E-02 : Overheat - Check for obstruction or damaged ducting 1E-10 : Ignition failure - Check fuel supply, blocked supply or fuel pump 1E-30 : Voltage too high 1E-31 : Voltage too low - check battery or voltage drop in supply cable 1E-52 : Overheat sensor failure 1E-70 : Fuel pump open circuit or ECU failure 1E-80 : Air motor failure 1E-90 : Glow pin failure 1E-d3: Maintenance Reminder