What does good tension for your belt on your boosted board look like? Check out our video and we'll show you. Visit our website - www.eboardstuff.com/ Check out our lifetime belts - www.eboardstuff.com/products/... #eboard #eboardstuff
That's awesome, and was the most trouble I had installing my 107mm Abec's. Initially I had slippage so I tightened them, but then had terrible noise! So had to experiment. This technique will help a lot, thanks!
Idk if I missed it, but You didn’t really cover how to adjust, what to loosen if it’s too tight. What to tighten up if it’s loose. I’ve got a tight belt and need to know what screws to loosen to make my belt do what you’re talking about.
so the cover is holding the tension? i am very confuse on how it holds tension. what is holding the tension? all i see is everything sliding in and out.
No. Motor bearings and shafts unlit fail on the v2 boards that were early production. Later in production they changed the material that the motor shaft was made of and The issue was eliminated.