How to Clear a Stuck Bullet - SQUIB 

I used a fiberglass pole that was 5 foot long and a bit smaller diameter than the 9mm. Put the pole behind the shortest travel for the bullet, and tapped the pole on the floor a few times popped right out. Worked great the 3 different times I have cleared my and other people obstructions.

You’re a pro. Thanks for the video.

Well done!

Literally just happend to me at the range like 10 mins ago all that happend was a puff of smoke that's all so I took the mag out ejected the casing and had to take my cleaning rod an had to push it out I'm glad I knew what to do I instantly unloaded an took the gun apart to take the barell out to check for a lodged round sure enough just the bullet was stuck in the barrell cleaned the barrell and shot fine no problem after that not bad tho 3000 rounds an only had this happen an only once so I'm sure it tends to happen eventually

Good job 👍🏼 but a lot of work, i just took an old chop stick i found in the car put a spent .22 case on it and bashed the squib out . It was a 38special in Ruger GP100 , and carried on shooting

Could this happen due to a polished/ sanded feed ramp/chamber tho?

Soo i have a 45 bullet stuck in my barrel, what size rod would fit that???

Does this help with a 9mm sccy

There is absolutely no need to do all that work in making a brass driver. Simply cut the rod to the appropriate length, deburr and then go to tapping or pounding the bullet out. Oh, and yes, I am a machinist with 40 years experience as well as being a hobbyist gunsmith.

That is just too much work they're a more simpler way of doing that wrap some tape around the extension rod so that it fits tight into the barrel put some tape on the bottle just tap it out done

What if you shoot a blank to expel the bullet?

Y not tap it out backwards? Mine popped right out instead of pushing it through.

Just use a wooden doll

Most inefficient and unnecessary way to clear a squib. I want my time back