How to connect the LED strips. Pike with his hands.
Channel Master himself: / @user-wz7vv2ic5u
The strip is implemented, usually in five coils meters. At one end of the tape (and sometimes two) are wires, which can be connected to the power supply.
Sometimes you need to cut the LED strips into pieces in connection with what are pieces of tape without wires. To be able to use these pieces of tape, you can connect them to the wires and solder them.
The best and reliable connection is soldered. Therefore, we need to solder power preferably not more than 25 watts, rosin, copper wire and the solder (preferably a different color).
How to solder the LED tape?
First you need to clean up the ends of the wires insulation. For convenience, the solder coating is sufficient to clean up about 5 mm.
Now you need to cover the insulation stripped of solder wire. To do this, put a wire on rosin, a soldering iron touch the copper wire. Thus rosin penetrates stranded wire.
Then, using a soldering iron cover copper wire solder. The solder must completely cover the wire on all sides and fill the entire space between the copper wires.
The second solder wire cover in the same way.
Side cutters remove excess wire to wire during operation of the LED ribbons are not locked together. It is enough to leave a 2 mm.
Now you need to cover the solder contacts on the tape.
Gaining a little on the soldering tip solder, rosin and then immediately touching one of the contacts the tape to produce a rubbing motion.
Once you see that the solder fixed on contact, remove the soldering iron, so as not to overheat the LEDs.
Then remove excess rosin around contacts.
If the tape does not form a small drop of solder, the soldering tip to recruit a little solder. Then applied previously prepared wire to LED strip. The sharp end of the soldering tip touch the contact ribbons and the flat side of the tip of wire.
As soon as the solder on the wire and to connect the tape in one drop, remove the soldering iron. Likewise, the second wire and solder.
If you need to connect several pieces of tape to each other, you can use solid conductors. Get them out of here, you can this on the internet simply said UTP cable. Inside it are solid conductors, that we should be fine.
To start cleanse copper wire from insulation, then cover them with rosin and solder.
When joining two pieces of LED strip, place them so that the contacts marked with + - plus were facing each other, as it is necessary to solder the positive to positive and negative to negative.
Solder a wire to one of your contacts, and circumcised him, leaving a small piece for connection with another piece of tape. After soldering the wires of the second trim the two wires.
When soldering a second piece of tape to the connecting wires attach metallic object such as scissors that wires are not sealed-off from the first tape.
If you intend connected so tape is applied to the metal surface must be insulated wires connecting the tape. This can be done with tape, glue gun or a shrink.
We check the availability of our tape. All properly soldered and connected.
Yourself Electrical: • Профиль для светодиодн...
Waiting for your opinions, reviews and comments. Ask your questions, leave requests for video-on-electrics. This will help me to do better and more interesting video for you. If you like this format of training video - subscribe to the channel.
6 фев 2017
