Just splice each end and push them together and fold them down. After that wrap a piece of wire around connection and heat it up with a mini torch. Push in the solder. Bingo, solid connection 👌
I love the way you showed absolutely the best way possible to join two stranded wires with the "two wire mesh" method and then walked away as if to say, "look closely and let that soak in for a while". Of course, wrapping with a single strand of wire is a must to keep the projecting ends held tight for the soldering. In my opinion, this is the very best way to solder stranded wire together. Very nice video! Thank you for your substantiation of making the method I've been using, the right way. Have you ever tried to pull the two wires apart after you mesh them, but before you solder them? It's like when you mesh two phone books together the same way. You can't pull them apart with two trucks! (On MythBusters)
I see a lot of guys in the comments saying "don't do it like this"-" trash" -"Mexican job"-"I wouldn't do it that way"-ect.... But don't elaborate on how they would do it?
I wouldn't do things this way but it is a solid connection! If I were to do it this way, I would add rubber tape, then friction before the electrical tape.
Aftermarket cable ends were installed on my Excursion before I bought it. Eventually, lead to very poor electrical connection to the battery. Ford no longer makes the positive battery harness and this technique is the only way to add new cable ends. It's not pretty, but if properly insulated it will get the job done.
Wow, What a Lousy Job. . . ! Done this before on a car, I know it’s much more difficult than it looks. Still, The connection was not wicked completely.
It is nice to see someone use a small butane torch for more conentrated heat rather than a regular torch but damn that is one ugly and unreliable joint.
If you knew how to solder it would be good, you are melting the solder with the torch instead of heating the wire enough to melt the solder and have it pull through. You are not getting full penetration with the solder. Sorry if you are not able to understand that. Good luck