How To Do A Led Upgrade On Gm, Chevy Steering Wheel Controls. 

your videos are a big help and very directional I appreciate you doing what your doing man.

Very informative and well done, if you want to see other great 12 volt videos Thank you for the content

What wires did you hookup to the power to get positive and negative?

very well explained. great job!

great job, your video help me a lot

just ordered the kit, looked all over your site to see if them come with instructions didnt find anything saying they do I hope it comes with picture tutorial instructions

Instead of using a Ohm meter to test for the positive contact couldn’t you just touch one of your new LED bulbs to the contacts to see which one lights it up?

Eaht wire did u connect for +and- to test it

What are your hours that you are open

Will blue LED square light for the steering wheel control light replacement.

I need the led # please thank you 😊

How many volts are the leds i have 12v leds left over from cluster work can I use them ???

Is there a option to send mine in and have you replace them?

External website link for the LED's that you use?

I just installed mine in green and they are great, however the lower right button is driving me crazy. I cannot get it to go together and have the power plug light the buttons. They do light when I test them with a tester, so the polarity is right and the solder connection is good. Something seems to be reversed but I cannot figure out what is wrong. The other 3 buttons went in fine and look great. The lower LED lights seem to be bigger and protrude more than the stock bulbs but the left one works, just a tight fit inside the unit . The lower right side is a different story. The 4 prongs do not sit properly in the case so when you try to put on the cap they become misaligned and don't go through the hole. If I flip the board around they fit perfectly and the cap goes on perfectly but then the plug does not illuminate the buttons, but the vehicle controls work! They just aren't lit. It's maddening. I watched a few other people comment in their videos that the lower right gave them more problems than the other three.

Just wondering where are y'all located

Which wires and color are you connecting your power supply to?

What do you use for your 12v source to test the LEDs and switches???

Where can we buy these blue LED lights, can you buy the switches with the blue lights already installed

Are the LEDs that you installed the "white" or "blue" ones??

Mine on my 2005 Denali don't light up at all none of them

Are these 3mm or 5mm

do you know the pinout or were i can find it for the harness i have an extra