It is a good video but the music is drowning out the instructor at times and the volume goes up and down so I am constantly adjusting the my volume to understand whats is going on.
Please get rid of that music! Besides the fact it stinks the volume goes from low to way too high then cuts out for commentary. Besides that, that for the video, very instructional.
I'd like to replace the carpet in the seating area of my Skeeter bass boat and I believe this will be the right stuff instead of seadec. How should I prep my floor after removing the carpet?
Remove old carpet. With a belt sander or orbital sander, remove as much of the carpet adhesive as comes easily. Don’t worry about adhesive remaining in the grain or small shards of adhesive that are difficult to remove. If bare wood is exposed, seal as described in “wood” section of these instructions. KiwiGrip will get a good bond to remaining adhesive and the shards will be lost in the KiwiGrip texture. You can read the complete KiwiGrip application instructions here: www.pyiinc.com/downloads/kiwigrip/kiwigrip-instruction-booklet.pdf
@@PYIinc I've read several reviews about this product staining easily on Amazon. Can ya'll shed so more light on these reviews and how easy is it to clean if need be?
@@jimmyboss8302 KiwiGrip generally cleans easier than most non-skids as it is not an aggregate based product that can leave exposed cups to collect dirt. Most daily use dirt and stains can be cleaned using a basic boat soap and light scrubbing with a scrub brush or push broom. For darker / hard to remove stains, a 10% bleach to 90% water solution can be used.